Buffalo Technology WRB-G54K, WLA-G54C Configuring your computers IP address, Windows XP/2000 users

Page 5

Step 2: Configuring your computers IP address

Windows XP/2000 users:

◗Click Start ➲ Control Panel

◗Double Click Network connections

◗Right-Click on appropriate Local Area Network Connection and select Properties.

◗Scroll down and highlight Internet Protocol (TCP/ IP) and then click Properties.

◗Select Obtain IP address automatically.

◗Click OK to close Internet Protocol (TCP/IP) Properties.

For Windows 98SE/ME

◗Right-click on Network Neighborhood and select Properties.

◗Select the Confi guration tab, scroll down to highlight TCP/ IP and click Properties.

◗Select Obtain IP address automatically.

◗Click OK to close Internet Protocol (TCP/IP) Properties.

◗Click OK to close Network Connection Properties.

■NOTE: The screen images below are for Windows XP. Consult the user manual for your specifi c operating system for further information on confi guring TCP/IP.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Package Contents Setup GuideAdditional Requirements Connecting cables Refer to Figure Setting up the Router WBR-G54Remaining Steps apply to both Wired and Wireless Setup Perform the next step for Wireless Router Setup onlyWindows XP/2000 users Configuring your computers IP addressAccess the AirStation configuration For DSL Service For Cable Broadband Service Advanced Settings Optional Determining the Best Location For the Repeater WLA-G54C Ensure you are connected Other Windows Versions Using Client Manager Software Surveying your Environment Typical two story residential placement of repeater Skip to section Check Signal Strength Other Windows Versions Client Manager Software Required Check Signal Strength Backing Up Backing Up and Restoring your ConfigurationPage Restoring WLA-G54C Wireless Compact Repeater Bridge Device Pre-configuration SettingsWBR-G54 Wireless Broadband Router WBR-G54 Specifications Wireless LANTCP/IP Http WLA-G54C Specifications
Top Page Image Contents