SOUND SIGNALS
A long warbling tone | Signals an incoming call |
|
|
Single Tone | A key is pressed |
|
|
Three short beeps | Error tone |
|
|
Two long beeps | Confirmation tone |
|
|
One short beep and one long beep | Page signal |
|
|
Two short beeps every 15 seconds | Low battery warning |
|
|
TROUBLESHOOTING
CALLER ID
No display
•Is battery fully charged? Try replacing the battery.
•Make sure that the base is connected to a
•Did you order Caller ID service from your local telephone company? The display will not work unless you do this.
Caller ID error message
•The phone displays this message if it detects anything other than valid Caller ID information during the silent period after the first ring. This message indicates either the presence of noise on the line, or that an invalid message has been sent from the telephone company.
TELEPHONE
No dial tone
•Check installation:
-Is the base power cord connected to a working outlet?
-Is the telephone line cord connected to the base unit and the wall jack?
•Disconnect the base from the wall jack and connect another phone to the same jack. If there is no dial tone in the second phone, the problem might be your wiring or local service.
•Is the handset out of range of the base?
•Make sure the battery is properly charged (12 continuous hours).
•Is the battery pack installed correctly?
•Did the handset beep when you pressed TALK/CALL BACK? Did the CHARGE/IN USE indicator come on? The battery may need to be charged.
27
