Sanyo CLT-J30 instruction manual LCD contrast, DND setting

INITIAL PROGRAMMING

LCD contrast

1.Make sure the phone is off (not in TALK mode).

2.Press FLASH/PROG until “LCD CONTRAST 3” shows on screen.

3. Press CID/VOL or , or press the number keys (1 – 3) to select the desired contrast level.

4.Press FLASH/PROG to store selection. You will hear a confirmation tone.

DND setting

This feature is for blocking calls during selected times. You can choose to block all calls, or only calls from non-VIP persons.

1.Make sure the phone is off (not in TALK mode).

2.Press FLASH/PROG repeatedly until “ENABLE DND 1 NO” shows on the screen.

3. Press CID/VOL or , or press the number keys 1-2 to select “NO” or “YES”.

4.Press FLASH/PROG again to store selection. You will hear a confirmation tone, and the following information will show on screen (if “NO” is selected then it will go to the next menu):

5.Press the number keys (0 – 9) to enter the start and stop times (12

hour format). Press CID VOL or to navigate between options. Press “*” to select AM. Press “#” to select PM.

6.Press PROG/FLASH again to store selection. You will hear a confirmation tone, and the following information will show on screen:

7. Press CID/VOL or , or press number keys (1-2) to select “ALL CALLS” or “ALLOW VIP”. “ALLOW VIP” allows numbers marked in the memory as VIP (very important persons) to get through, even when DND is ON. To block all calls, press 2. This will prevent the phone from ringing during the selected time, no matter who calls.

Note: As the DND feature is dependant on Caller ID information, the first ring will always sound.

11