Sanyo CLT-J30 Initial Programming, Language setting, Area code setting, Ringer tone

INITIAL PROGRAMMING

Before using this telephone, 7 initial settings must be completed on the handset: Language, Area code (this is required to use Caller ID service from your telephone company), Ringer tone, Tone/Pulse setting, LCD contrast, Do Not Disturb (DND), and Idle Animation.

Language setting

1.Make sure the phone is OFF (not in TALK mode).

2.Press FLASH/PROG until “ 1 ENG 2 FRA 3 ESP” shows on screen.

3. Press CID/VOL	or	, or the number keys (1 – 3) to select the
desired language.

4.Press FLASH/PROG to store selection. You will hear a confirmation tone.

Area code setting

For proper Caller ID operation, you must program your area code.

1.Make sure the phone is OFF (not in TALK mode).

2.Press FLASH/PROG until “AREA CODE - - - “ shows on screen.

3.Enter your 3-digit area code using the number keys. To change a digit, press CH/DEL and then re-enter the number.

4.Press FLASH/PROG to store selection. You will hear a confirmation tone.

Ringer tone

There are 6 melody ringer tones available for models J50 and J60 or 3 tones for J30, J40 and J40(BK).

1.Make sure the phone is OFF (not in TALK mode).

2.Press FLASH/PROG repeatedly until “RINGER TONE 1” shows on screen.

3. Press CID/VOL or , or press the number keys 1-3 or 1-6 (depending on the model) to select the desired ringer tone.

4.Press FLASH/PROG to store selection. You will hear a confirmation tone.

Note: If type1-type 4 (melody) is selected, the handset melody will continuously ring for 11 seconds after the line is dropped or a parallel phone picks up the line.

Tone/pulse setting

1.Make sure the phone is off (not in TALK mode).

2.Press FLASH/PROG until “ 1 TONE 2 PULSE” shows on screen.

3. Press CID/VOL or , or press the number keys 1-2 to select TONE or PULSE.

4.Press FLASH/PROG to store selection. You will hear a confirmation tone.

10