Buffalo Technology WRB-G54K Setting up the Router WBR-G54, Connecting cables Refer to Figure

Page 3

Setting up the Router WBR-G54

■Note: You can use either a Wired or Wireless connection from the PC you are using to setup your router. It is strongly recommended you use the Wired method to avoid possible errors or connection issues during the initial setup.

STEP 1. Connecting cables (Refer to Figure 1):

Figure 1: Connecting Cables

◗Ensure your Cable or DSL modem, Wireless Router, and the computer you will be using to setup the Router, are powered off prior to connecting cables.

◗Locate your DSL or Cable Modem LAN cable and connect it to the appropriate port on your Modem as per instructions from your Modem’s manufacturer.

◗Connect the other end of this cable to the port marked WAN on the back of the Router.

3

Image 3

Contents Package Contents Setup GuideAdditional Requirements Connecting cables Refer to Figure Setting up the Router WBR-G54Remaining Steps apply to both Wired and Wireless Setup Perform the next step for Wireless Router Setup onlyWindows XP/2000 users Conﬁguring your computers IP addressAccess the AirStation conﬁguration For DSL Service For Cable Broadband Service Advanced Settings Optional Determining the Best Location For the Repeater WLA-G54C Ensure you are connected Other Windows Versions Using Client Manager Software Surveying your Environment Typical two story residential placement of repeater Skip to section Check Signal Strength Other Windows Versions Client Manager Software Required Check Signal Strength Backing Up Backing Up and Restoring your ConﬁgurationPage Restoring Device Pre-conﬁguration Settings WBR-G54 Wireless Broadband RouterWLA-G54C Wireless Compact Repeater Bridge WBR-G54 Speciﬁcations Wireless LANTCP/IP Http WLA-G54C Speciﬁcations