Znyx Networks ZX4300P manual Connector Pinouts

Page 16

Connector Pinouts

Notes for J Connector Pinouts from Previous Tables

Sections referenced below pertain to the CompactPCI Packet Switching Backplane PICMG 2.16 Draft 0.6.5 June 19, 2001

1.BP(I/O) connects Front card to Rear card and does not connect to backplane. Refer to Section 3.1.1.2 for Alternate Node Board Keying Compliance.

2.GND for Type B style J3 connector.

3.Refer to Sections 3.3.2.3, 3.3.3.7, 3.3.5.1, 3.3.6.1, 4.3.5, 4.3.6, 4.4.1, and 4.4.10.

4.Refer to Sections 3.3.3.8, 3.3.6.2, 4.3.7, 4.4.1, 4.4.9, and 4.4.10.

5.Refer to Sections 4.3.6 and 4.4.5.

6.Refer to Section 4.4.6.

7.Refer to the PICMG 2.0 Rev 3.0 CompactPCI Specification.

8.Required as per PICMG 2.0 Rev 3.0 CompactPCI Specification.

9.Refer to Sections 3.3.1.4 and 3.3.4.3.

10.Refer to Section 3.5.1.3.

11.Refer to Sections 3.3.1.1, 3.3.4.1, and 4.4.2.

12.Refer to Sections 3.3.1.3 and 4.3.4.

13.Refer to Sections 3.3.1.5 and 4.3.1.

14.In accordance with PICMG 2.1 R2.0.

15.Refer to Sections 3.5.1.1 and 3.5.2.1.

16.Signal edge rate shall not exceed 6.4 V/ns. Refer to Section 4.4.10.

17.Signal edge rate shall not exceed 12.8 V/ns. Refer to Section 4.4.10.

18.Refer to Sections 3.3.1.7 and 3.3.4.5.

ZX4300P Series User's Guide

Page 13

Image 16
Contents ZX4300P 10/100 Ethernet Switch Copyright Notice About this Manual Technical SupportOverview of the ZX4300PSwitch ZX4300P Models Features of the ZX4300PSwitchRear Transition Board RTB models for the ZX4300P Preparing for the Install InstallationInstalling the ZX4300P cPCI Card Installing the Rear Transition Board RTB Connecting the Cables LED ReferenceZX4300P Series LED Reference Key LEDLegal Notices and Certification FCC Class a Notice ZX4300P SeriesConnector Pin Assignments Standard and Extended Board J5 Pin AssignmentsExtended Fabric Board J4 Pin Assignment Standard and Extended Fabric Board J3 Pin Assignment PinNode & Fabric Board J2 Pin Assignment Node & Fabric Board J1 Pin Assignment Connector Pinouts Patch Panel Cable Specifications Figure D-1 Cable Attached to the ZXRTB24RUTPCH8SR25