Znyx Networks ZX4300P manual Installing the Rear Transition Board RTB

Page 7

Installation

Installing the Rear Transition Board (RTB)

1.Remove the slot cover (or covers) from the corresponding rear panel bracket (slot filler) on your system.

2.Insert the correct Rear Transition Board into the slot.

NOTE: Exercise extreme care when inserting the RTB card into the chassis. Improper alignment of the rear transition card connector with the rear panel connector pins can damage the pins. Your switch includes AB connectors to assist in properly aligning the RTB for insertion. Follow the same insertion precautions as the switch.

3.Push the extraction levers towards one another to finish seating the RTB and secure the retention screws.

ZX4300P Series User's Guide

Page 4

Image 7
Contents ZX4300P 10/100 Ethernet Switch Copyright Notice Technical Support About this ManualOverview of the ZX4300PSwitch ZX4300P Models Features of the ZX4300PSwitchRear Transition Board RTB models for the ZX4300P Preparing for the Install InstallationInstalling the ZX4300P cPCI Card Installing the Rear Transition Board RTB LED Reference Connecting the CablesLED ZX4300P Series LED Reference KeyFCC Class a Notice ZX4300P Series Legal Notices and CertificationStandard and Extended Board J5 Pin Assignments Connector Pin AssignmentsExtended Fabric Board J4 Pin Assignment Pin Standard and Extended Fabric Board J3 Pin AssignmentNode & Fabric Board J2 Pin Assignment Node & Fabric Board J1 Pin Assignment Connector Pinouts Figure D-1 Cable Attached to the ZXRTB24R Patch Panel Cable SpecificationsUTPCH8SR25