Zhone Technologies 08-01002-01 manual Step Action, You have completed this task

Installing the Elite Modem 1-5

Task:

Installing the Modem

Note: Some computers require an adapter between the RJ-45 Ethernet cable and the Ethernet connector on the back of the computer (the adapter is often a round, 8-pin connector).

Step Action

1Make sure that all of your Elite Modem equipment is available before proceeding.

2Connect the RJ-45 Ethernet cable to the 10Base-T Ethernet Card connector on the rear of your computer. Connect the other end of cable to the Ethernet port on the rear of the modem labeled: To PC.

3Your telephone is connected with an RJ-11 modular phone line cord to a telephone wall jack. Disconnect the telephone line cord from the telephone wall jack and insert it into the jack in the rear of the modem identified with this icon:

4Connect the RJ-11 modular phone cord to the connector on the rear of the modem labeled, To Wall Jack. This connector is identified with a telephone line symbol.

5Insert the other end of the phone cord into the telephone wall jack.

6Connect the rounded plug end of the power supply cord into the 5V AC connector on the rear of the modem.

7Plug the power supply into wall outlet. This completes the modem physical installation. Proceed to Setup. At this point, the Power and the Loop Status indicator lights should be green.

Note: See “Modem Indicators” on page 1-6for more information on the Elite modem LED indicators.

STOP

You have completed this task.

Revision 2.01 Elite Modem Installation Guide 08-01002-01