Testing the Connections, Mounting the Stereo

Connecting the Antenna

Connect the vehicle's antenna cable to the stereo's large black antenna connector.

Checking the Connections

Make sure you have securely made all connections before continuing with the installation.

Connecting the Battery and the Harness

Plug the harness' connector into the stereo's 14-pin wiring socket, then reconnect the cable to the vehicle battery's negative terminal.

TESTING THE CONNECTIONS

Turn on your vehicle's ignition, install your stereo's control panel and test the stereo.

The display should light when you press ON/OFF to turn on the stereo.

If the stereo does not work, immediately disconnect the cable from your vehicle battery's negative (-) terminal. Then recheck your connections.

Caution:

If you played a CD while testing the connections, be sure to remove the CD from the stereo before continuing.

Be sure you test the stereo first and verify that it works properly. Then follow these steps to mount the stereo.

1.Disconnect the cable from the vehicle battery's negative (-) terminal.

(new illus)

2.Disconnect the wire harness and the antenna. (new illus)

3.You must remove the stereo's control panel to remove the sleeve To remove the control panel, press RLS.