Installation
Components
This section describes the front- and
The FS4016E is similar to the other Switches. It has an uplink pushbutton switch on the front panel but does not have any controls on the back panel. The duplex/NWay function provided by the Ports Half Duplex Full NWay DIP switch in the FS4002E/FS4004/FS4008 units is implemented automatically in the FS4016E. T he function status is indicated by a row of FDP
The Uplink pushbutton switch is connected to a single port on each Switch. In Normal position, the port associated with the switch operates like any other port on the unit. When the Uplink pushbutton is in the depressed position, the port associated with the switch becomes an uplink port and eliminates the need for a crossover cable.
Cable tie points are provided on the back panel of the FS4002E and FS4004E Switches and may be used to secure the power cord to the panel.
FS4002E
The front panel of the FS4002E contains two 10/100Mbps ports, one uplink switch button, and LED indicators. See Figure
Uplink Port (Selector)
FRIENDLYNET | FS4002E |
|
|
| ||
1 | 2 | 1 | 2 | or |
|
|
|
| Uplink |
Power |
| 10/100Mbps Ports |
| |
|
|
| ||
LEDs | Two 10/100 Ports |
Figure 2-1 FriendlyNet FS4002E front panel
The back panel of the FS4002E contains a 12Vdc power connector, which uses a 115Vac receptacle-mount (or “brick”) type dc power supply. It also contains a Ports switch consisting of two DIP switches. The DIP switches set the mode of operation for each port, either Half Duplex or Full NWay. See Figure 2-2 .
Page