Asante Technologies FS4002E/FS4004E user manual Wall Mounting the FS4002E, FS4004E, and FS4008E

Page 17

Mounting Configurations

Wall Mounting the FS4002E, FS4004E, and FS4008E

The FS4002E, FS4004E, and FS4008E come with a wall-mount kit. The kit consists of screws and wall anchors.

Important! The FS4016E cannot be wall-mounted without the optional wall mount kit, part number 99-00486--07.

To mount the FS4002E, FS4004E, and FS4008E on a wall, consider the following when selecting a site:

Select a site that is free of obstructions from other equipment or devices

Place the Switch high enough to easily observe LED indicators and to allow for easy power and cable access

Decide how you want the orientation of the front panel.

To mount the FS4002E, FS4004E, or FS4008E on a wall:

1

2

Measure the screw holes on the bottom of the Switch.

Drill two holes into the wall equalling the same distance as measured in step 1.

Important! Drill the holes only to the depth of the screw’s length. If the holes are too deep, the mount may not be secure.

3 Insert the plastic anchors (supplied) into the drilled holes and gently tap them in with a hammer.

4 Insert and turn the screws (supplied) into the plastic anchors, leaving a small portion of the screws sticking out.

Important! If the screw head is too high and the unit stands too far off the wall, accidental pressure could cause screw heads to press into the circuit board, and result in damage.

5 Lift the Switch and align the slots on the bottom of the Switch with the screw anchors.

6 Gently slide the Switch onto the screws.

The Switch wall mounting is complete. The Switch is ready for network connections.

Page 2-7

Image 17 Asante Technologies FS4002E/FS4004E user manual Wall Mounting the FS4002E, FS4004E, and FS4008E, Mounting Configurations
Contents FriendlyNet 4000E Series Limited Lifetime Warranty Table of Contents Troubleshooting Specifications Technical Support About This Manual Chapter ContentsDocument Conventions Introduction FriendlyNet Fast Ethernet SwitchIntroduction FeaturesFast Ethernet and Switching Technology Performance FeaturesPerformance Features Fast Ethernet TechnologySwitch Acts as a Bridge Between Network Segments Switching TechnologySwitch Supports Network Expansion Package Contents InstallationFS4002E InstallationComponents Components FS4004EFS4016E FS4008ECabling and Voltage Requirements Cabling and Voltage RequirementsCabling Requirements Desktop Mounting Mounting ConfigurationsVoltage Requirements Wall Mounting the FS4002E, FS4004E, and FS4008E Mounting Configurations10 Attaching mounting brackets to the FS4008E Rack Mounting the FS4008E or FS4016EConnecting Network Devices Connecting Network DevicesConnecting a PC to the Switch Connecting a Hub with no Uplink Port to the Switch Connecting a Hub or a Switch to the Asanté SwitchPowering on the Switch Powering on the SwitchFS4002E and FS4004E FS4008E and FS4016EInstallation LED Indicators on the Switch LED IndicatorsLED Indicators LED Indicators for Power OnState Status LED Indicators for Port ConnectionsLED Indicators on the Switch Activity LEDs Problem Action TroubleshootingA-2 FS4000E Series Specifications SpecificationsFS4000E Series Performance Specifications FS4000E Series Physical and Environmental SpecificationsContacting Technical Support Technical SupportPage Page Asanté TECHNOLOGIES, INC., 821 FOX LANE, SAN JOSE, CA