Aiwa XP-SP921 Maintenance, Specifications, To clean the lens → N, To clean the discs → O

M

N

O

at the end of the track to select the other lay mode, the unit may not change to the other mode properly.

CONNECTING TO AN EXTERNAL UNIT → M

Use a commercially available connection cord which has a 3.5 ø stereo mini-plug at one end and two phono plugs at the other end.

Connect the stereo mini-plug to the PHONES/LINE OUT jack of the unit and connect the phono plugs to the analog input terminals of the external unit, such as the amplifier or the equipment with the built-in amplifier. The CD sound can be heard through the connected audio system.

Note

•Turn off the power of both units before connection.

•DO NOT connect to the PHONO inputs of an amplifier (with a built-in phonoequalizer-amplifier).

•Adjust the volume and DSL on this unit.

MAINTENANCE

To clean the lens → N

If the lens becomes dirty, the player will skip or not play. If this occurs, clean the lens in the following manner.

To remove dust or dry particles, first use a camera lens blower/brush a to blow a few times to loosen particles, then gently brush the lens bclean. Finish by blowing the lens again.

To remove fingerprints, use a cotton swab dipped in lens cleaning solution. Wipe gently from the center to the edge. Lens cleaning solution is commercially available.

Note

•Take care not to get too much solution on the swab, which could flow into the unit and cause damage.

•Pressing too strongly with the swab could scratch or break the lens.

To clean the discs → O

Before playing, wipe the disc from the center outward with a cleaning cloth. After playing, store the disc in its case.

SPECIFICATIONS

Tracking system	3-beam laser
Laser pickup	Semiconductor laser
D/A conversion	8-times oversampling digital filter + 1-bit DAC
Frequency response	20 – 20,000 Hz (47 k ohms)
Output	PHONES/LINE OUT jack (stereo mini-jack)
Maximum output	12 mW + 12 mW (16 ohms at 1 kHz)
Power supply	500 mV (47 k ohms at 1 kHz)
	DC 3 V using two size AA (LR6) alkaline batteries
	DC 2.4 V using commercially available rechargeable
	batteries
	AC house current using the supplied AC adaptor
Maximum outside dimensions
	134 (W) ⋅ 30 (H) ⋅ 140 (D) mm
	(excluding projecting parts and controls)
Weight	(5 3/8 ⋅ 1 3/16 ⋅ 5 5/8 in.)
	Approx. 277 g (9.7 oz.) excluding batteries
Accessories	AC adaptor AC-D603 (1)
	Stereo headphones (1)
AC adaptor AC-D603	Carrying case (XP-SP921 only) (1)
	Rated input: AC 120 V, 60 Hz

The specifications and external appearance of this unit are subject to change without notice.

ATTENTION:

The product you have purchased can be powered by nickel cadmium batteries which are recyclable. At the end of their useful life, under various state and local laws, it is illegal to dispose of these batteries into your municipal waste stream.

Please call 1-800-289-2492 for information on how to recycle these batteries.