Westell Technologies 36R570 Multiple-User Setup, WireSpeed Pro Single-User Setup Connections

ADSL WireSpeed Pro 36R570 Proxy Router

User Guide

6.The Link LED should be solid green indicating that the CPE connection has been made.

7.During use, a pulsing yellow Activity LED indicates that data is being transmitted and received on the Ethernet interface.

8.Proceed to page 16, “Setting Up Your WebShare Account” to configure the software.

ADSL LINE

ON/OFF

SWITCH POWER ETHERNET

CONNECTOR

Figure 1. WireSpeed Pro Single-User Setup Connections

Multiple-User Setup

Refer to the wiring diagrams in Figure 2 and Figure 3.

1.Connect the power supply cord to the power connector on the side of the WireSpeed Pro and plug into a power receptacle.

2.Connect a standard RJ-11 telephone cable from the LINE connector to the ADSL-equipped phone line.

3.Obtain a multi-port Ethernet Hub (available separately). Ensure that the hub includes enough Ethernet ports to meet the requirements of the network.

4.Connect the straight 10Base-T cable (included with this package) to the jack labeled ETHERNET on the side of the unit to the jack-designated uplink on the Ethernet Hub. With some Ethernet Hubs, a crossover cable (available separately) may be required. Please see the documentation included with the selected Ethernet hub.

5.Connect each additional PC to the Ethernet hub.

6.Turn the power switch ON.

030-300153A 7 WireSpeed Pro Installation