Westell Technologies 2110 guide

User Guide

WireSpeed Dual Connect Modem

3.Connect the DSL phone cable from the connector marked on the rear panel of the modem marked to the DSL-equipped telephone line jack on the wall. IMPORTANT: Do not use a DSL filter on this connection. You must use the phone cord that was provided with the modem kit.

4.Connect the USB cable from the USB connector marked on the rear panel of the modem to the USB port on the PC.

Note: When changing the modem between multiple computers with different operating systems or when upgrading the computer attached to the modem, the power must be cycled on the modem.

5.6.2Modem Installation via 10/100 Base-T/Ethernet

Note: Before you connect the modem via 10/100 Base-T, you must have an available Ethernet card installed in your computer. If your Ethernet card does not auto-negotiate, you must set it to half duplex. Refer to the Ethernet card manufacturer’s instructions for installing and configuring your Ethernet card.

Figure 3. Modem Connection via 10/100 -Base-T/Ethernet

Refer to Figure 3.

1.Verify that you have an available Ethernet card. Note: See the above caution box.

2.Connect the power supply cord to the power connector marked 12V on the rear panel of the modem. Plug the other end of the power supply cord into an AC wall socket.

3.Connect the DSL phone cable from the jack on the rear panel of the modem marked to the DSL-equipped telephone line jack on the wall. IMPORTANT: Do not use a DSL filter on this connection. You must use the phone cord that was provided with the modem kit.

4.Connect the Ethernet cable from the Ethernet jack markedon the rear panel of the modem to the Ethernet port on your computer.

030-300196 Rev. A