Navini Networks 40-00097-00 manual Regulatory Information, FCC Compliance and Advisory Statement

Page 5

Navini Networks, Inc.

Ripwave Modem User Guide

Regulatory Information

FCC Notice

CAUTION: This device is a Radio Frequency transmitter. It is required to comply with FCC RF exposure requirements for transmitting devices. A minimum separation distance of 8 inches (20 cm) or more must be maintained between the antenna and all persons during device operations to ensure compliance with the FCC’s rules for Radio Frequency Exposure. If this minimum distance cannot be maintained, exposure to RF levels that exceed the FCC’s limits may result.

FCC Compliance and Advisory Statement

Tested To Comply

With FCC Standards

FOR HOME OR OFFICE USE

This equipment has been tested and found to comply with the limits for a class B digital device, Pursuant to Part 15 of the FCC rules. The operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)This device must accept any interference received, including interference that may cause undesired operation.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed or used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1)Reorient or relocate the receiving antenna;

2)Increase the separation between the equipment and the receiver;

3)Connect the equipment to an outlet on a circuit different from that to which the receiver is connected;

4)Consult the dealer or an experienced radio/TV technician for additional suggestions.

INFORMATION TO USER

This device has been authorized as a radio frequency transmitter under the appropriate rules of the Federal Communications Commission. Any changes or modifications not expressly approved by Navini Networks could void the user’s authority to operate the equipment.

Part #40-00097-00 Rev E v1.0

Copyright © 2003 Navini Networks, Inc. All rights reserved.

5

July 30, 2003

 

 

Image 5
Contents For use with all Ripwave Modem models Ripwave Modem User GuideTable of Contents Permissions, Trademarks & Distribution Safety FCC Compliance and Advisory Statement Regulatory InformationBattery Precautions GHz Model 2.5 & 2.6 GHz Models Introduction Package InventoryRipwave Models Model Frequency Range Operating Port Band Connection Operating Frequencies Computer ConnectionsGeneral Information Minimum Computing RequirementsHard Drive MonitorGHz Ripwave Modem Physical Characteristics2.5 & 2.6 GHz Ripwave Modems Step Action Illustration Installing an Ethernet ModemInstalling an Ethernet Modem Installing an Ethernet Installing a USB Modem Installing a USB Modem Step Action Illustration ‘NETNNUSB.INF Accessing the Internet Indicator Lights TroubleshootingBefore you install, please note Installing Navini MonitorInstalling Navini Monitor Step Action Illustration Step Action Illustration Using Navini Monitor Ripwave Modem User Guide Navini Networks, Inc Navini Networks, Inc Ripwave Modem User Guide Uninstall Uninstalling Navini MonitorPrograms Navini Navini Monitor Uninstall Navini GHz Battery Installing Charging BatteryGHz, 2.5 GHz & 2.6 GHz Battery Care & Maintenance Upgrading the Modem Operating System Ethernet interface USB interface Addendum 1 Ripwave Modem PC TroubleshootingEthernet Interface Results of Correct Navini Monitor Installation Navini Networks, Inc Ripwave Modem User Guide \WINDOWS\ END-USER License Agreement for Ripwave Software Addendum 2 End User Software License AgreementDescription of Other Rights and Limitations Navini Networks, Inc Ripwave Modem User Guide WARRANTY. the Software is Provided on AN AS is Basis Without END of Agreement