Multitech RF820-AP, RF830-AP manual Fqdn

Page 64

Chapter 5 – Configuration Using Web Management Software

VPN > IPSec > Add Manual Connection

Left Next Hop

Next Hop is the address of the next device in a routing table’s path that moves a packet to it’s destination. This setting can be configured or left as a static value: 0.0.0.0. When not configured, the value is set to the Gateway of the Box/Gateway configured on the Interface/Right IP. The selection is based on the Left and Right IP.

Local WAN IP

Select the Interface to initiate the IPSec tunnel (Left Security Gateway). Options are LAN, WAN1, and WAN 2 (for the RF830/RF830-AP only).

Local LAN

Select the internal subnet of the local security gateway for which the security services are to be provided. If the RouteFinder acts as a host, this should be configured as None. Other options are: Any, LAN, LAN Interface, WAN 1, WAN 1 Interface. (RF830/RF830-AP includes WAN 2 and WAN 2 Interface options).

Remote Gateway IP

Select the interface in which the IPSec tunnel ends. In the case of Road Warriors with a Dynamic IP addresses, this should be configured as ANY. Other options include: LAN, LAN Interface, WAN 1, WAN 1 Interface, and None. (RF830/RF830-AP includes WAN 2 and WAN 2 Interface options).

FQDN

FQDN is a DNS resolvable fully qualified domain name with which identity the right peer can be identified. When FQDN is entered, the Remote Gateway IP should be blank.

Remote LAN

This is the internal subnet of the remote security gateway for which the security services are to be provided. If the remote end is a host, this should be configured as None.

Failover (available on the RF830/RF830-AP only)

Check the box to enable VPN failover for the tunnel. When this field is enabled, the tunnel will failover on to the other interface if its local interface is down. For example, if the tunnel is configured on WAN 1 but the link goes down, the tunnel again comes up on the link that is up (i.e., LAN 2). Failover is possible only when the remote gateway is an FQDN (Fully Qualified Domain Name) and Dynamic DNS Failover is enabled (see the Network > Dynamic DNS screen).

NetBIOS Broadcast

Check this option to enable broadcasts over the connection. It will allow computers on the network to share Microsoft file and printer sharing information.

Multi-Tech Systems, Inc. RouteFinder SOHO RF820/RF820-AP & RF830/RF830-AP User Guide (S000399E)

64

Image 64

Contents RouteFinder→ Soho Warranty Trademarks Revision Date DescriptionPatents World HeadquartersContents Key Features Introduction DescriptionFeature Details RouteFinder Ship Kit Contents RouteFinder DocumentationTelecom Warnings for the Modem RF820/RF820-AP Front Panel RF830/RF830-AP Front PanelLEDs DescriptionBack Panels ConnectorRF820 RF820-AP RF830 RF830-AP Typical Applications Specifications RF820 and RF820-AP RF830 and RF830-AP SpecificationsVPN Specifications Specifications for 802.11b/g InterfaceRF8230AP and RF830AP Installation Cabling Your RouteFinderRF820 RF820-APRF830 RF830-APSetting up a Workstation and Starting RouteFinder Establish TCP/IP CommunicationTo Set a Fixed IP Address Click the Properties buttonOpen a Web Browser Navigating the Screens Menu Bar Sub Other Options Screen Name Input AreaNetwork Setup Wireless Menu BarSub-Menus Table of Menus and Sub-MenusStart the RouteFinder Configuration Configuring RouteFinderAbout IPSec Using the Wizard Setup Screen to Configure Your RouteFinder RouteFinder Initial ConfigurationWizard Setup Screen NotesWAN 1 Dhcp Client Choice ISP SettingsWAN 1 Static IP Choice WAN 1 PPPoE Choice MTU Save to Flash Memory Important Note About Save and RestartRestart Configuration Using Web Management Software AdministrationAdministration System Setup Administration System SetupConfigure Email Notification Auto Reboot TimerEmail Address Administration Administrative Access Administrative AccessAdministration Administrative Access Screen NoteChange Password Administrative Access Http PortOld Password, New Password, Confirmation Web Interface Inactivity Time OutAdministration System Logs Administration Remote SyslogAdministration System Logs Administration Remote Syslog Remote SyslogAdministration Sntp Client Sntp ConfigurationAdministration Sntp Client General ConfigurationAdministration Sntp Client Time Zone Configuration Daylight ConfigurationDaylight Saving Start Time Daylight Saving End TimeAdministration Tools Administration ToolsAdministration Factory Defaults Reset ModemReset to Factory Defaults Administration Tools Administration Factory DefaultsNetworks & Services Network Configuration Networks & ServicesNetworks & Services Network Configuration RF830/RF830-AP Network Configuration Screen Network Configuration FieldsHow to Confirm Your Entries Important Network NotesNetworks & Services Service Configuration Networks & Services ServicesThis is an example of screen with the TCP protocol selected Service Configuration Editing and Deleting User-Added ServicesTCP, UDP, and TCP& UDP AH and ESPNetwork Setup IP Settings Network SetupNetwork Setup IP Settings WAN Choice Dhcp Client Default Default GatewayWAN Choice Static IP WAN 1 & WAN 2 WAN 2 is for the RF830/RF830-AP onlyWAN Choice PPPoE Network Setup Wireless LAN Wlan SettingsNetwork Setup Wireless LAN Wlan Security Security Selection DisableWlan Security Select SecurityWEP Key to Index Network Setup Wireless LAN Wlan Security WEP KeyWPA-PSK/WPA2-PSK Key Group Key Rekeying Network Setup Wireless LAN Wlan Client Filter Access Control ListNetwork Setup Advanced IP Settings Network Setup PPP Cellular/Analog Backup PPP Client for Cellular/Analog Modem BackupNetwork Setup PPP Cellular/Analog Backup Screen Note This screen applies to the RF820/RF820-AP onlySignal Strength only for Cellular Modems Modem Initialization StringsSIM Initialization String only for Cellular Modems PPP Keep-Alive ParametersNetwork Setup Load Balancing Load Balancing Weight ConfigurationLoad Balancing Keep Alive URL Configuration Network Setup Load BalancingNetwork Setup Dynamic DNS Network Setup Dynamic DNSDdns Failover for the RF830/RF830-AP only Use Wildcard Custom DNSCheck IP Check IP ServerNetwork Setup Static Routes Network Setup IP MasqueradingNetwork Setup Snat Network Setup SnatService Network Setup Dnat Network Setup DnatAdd Dnat Definition WAN IPPacket Filters Packet Filter Packet Filter RulesServices From Host/NetworksTo Host/Networks ActionPacket Filters Advanced Filters Packet Filters Advanced FiltersPacket Filter Icmp Packet Filter Packet Filter LogIcmp Forwarding Icmp on FirewallVPN Virtual Private Network VPN IPSecVPN IPSec Add a New ConnectionAdd an IKE Connection Add IKE ConnectionNetBIOS Broadcast VPN IPSec Add IKE Connection Key LifeNumber of Retries Left Next HopAdd Manual Connection Add a Manual ConnectionVPN IPSec Add Manual Connection Fqdn Pptp Settings Pptp StatusEncryption Strength Select Remote AddressAuthentication Type User AuthenticationAuthentication Type Select Radius Proxy Proxy Http ProxyHttp Status Http Allowed NetworksProxy Custom Filters Proxy DNS Proxy DNS ProxyProxy DNS Proxy LAN StatusDhcp Server LAN Subnet Settings Dhcp Server LAN Subnet SettingsDhcp Server Dhcp Server on LANAdd Fixed Address Dhcp Server Wlan Subnet Settings and Wlan Fixed AddressesAdd Fixed Address Utilities Backup Utilities Firmware UpgradeUtilities Backup Utilities Firmware Upgrade BackupStatistics & Logs Statistics & Logs System InformationStatistics & Logs System Information RF820/RF820-AP Screen RF830/RF830-AP ScreenAll Access Requests to Firewall Violating Security Policy Log Access to Administrative Access PortStatistics & Logs Network Interface Details Statistics & Logs Packet Filter LogStatistics & Logs Pptp Live Log Statistics & Logs IPSec Live LogStatistics & Logs Dhcp Server Live Log Statistics & Logs PPP Cellular/Analog Log Statistics & Logs Wlan Client Live LogStatistics & Logs Log Traces Statistics & Logs Log TracesTroubleshooting System Diagnostics as a Troubleshooting ToolProblem #4 Frequently Asked Questions How do I access the Router’s setup pages with a Mac? If all else fails in the installation, what can I do?How will I be notified of new router firmware upgrades? Which modems are compatible with the router?Appendix a Table of Commonly Supported Subnet Addresses Network Number Hosts Available Broadcast Address Appendix B Antenna for Wireless RouteFinder Antenna Electrical CharacteristicsAntenna MechanicalAppendix C Waste Electrical Electronic Equipment Directive WeeeGlossary AESIKE Isdn TA Pptp PingSsid Tkip WEPWlan Wireless Local Area Network WPA-PSKIndex Data Encryption Standard DES DefinitionNetwork Setup PPP Cellular/Analog Modem Stats & Logs Dhcp Server Live Log