Sprint Nextel manual Regulatory Notices, FCC ID PKRNVWC201

Page 67

Warning (EMI) – United States FCC Information –

Regulatory Notices

This device complies with Part 15 of the FCC Rules. Operation of this device is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesirable operations. FCC guidelines stipulate that the antenna should be more than 1.5 cm (5/8”) from all persons.

FCC ID: PKRNVWC201

Where appropriate, the use of the PCS Connection Card is subject to the following conditions:

Caution – Unauthorized modifications or changes not expressly approved by Novatel Wireless, Inc. could void compliance with regulatory rules, and thereby your authority to use this equipment.

This equipment

has been tested and found to comply with the limits pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in an appropriate installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

▶Reorient or relocate the receiving antenna,

▶Increase the separation between the equipment and receiver,

▶Connect the equipment into an outlet on a circuit different from that to which the receiver is connected,

▶Consult the dealer or an experienced radio/TV technician for help.

Section 6

Safety and Regulations 63

Image 67

Contents User’s Guide Page Table of Contents Troubleshooting Tips Thank you for choosing Sprint Welcome to SprintPage Introduction to this User’s Guide Page Getting Started With Your PCS Connection CardTM Before you can use your PCS Connection Card, you must first Your PCS Connection CardGetting Started PCS Connection Card ComponentsSystem Requirements Launch the Wireless Connection Manager Software applicationCare and Maintenance Keep the card in a dry, clean spaceTo install the Wireless Connection Manager Software Installing the Wireless Connection Manager SoftwareLicense Agreement window Desktop Icon message Drivers. The Found New Hardware window or Found New Inserting and Removing Your PCS Connection Card Sprint Welcome window will appear see Figure Activating Your PCS Connection CardIf your card is intended primarily for personal use Carefully repeat the Electronic Serial Number to Click Finish to exit the Sprint Activation Wizard Wireless Connection Manager Consists of the following items Wireless Connection Manager Main WindowSprint URL PCS Connection Card Status Mail Icon Lock Icon Connecting to the NetworkCompression Option window Controlling CompressionQuitting the Wireless Connection Manager Application Disconnecting From the NetworkShowing and Hiding the Wireless Connection Manager Hiding the Wireless Connection Manager Task Bar Detailed Status Report window Total Bytes FieldsClearing the Total Bytes Fields Select Yes to lock the device Locking and Unlocking Your PCS Connection CardTo lock your card Confirmation window will appear see FigureEnter Lock Key window will be displayed see Figure To unlock your cardPop-Up menu System Tray IconsViewing a Web Message Using the Web Messaging FeatureCallback No, and the date the message was received Click Send Using your Web browser Select the Phone tabSending a Web Message There are three ways to send a Web messageInstalling the PCS Software Modem Using the Optimized RAS OptionDeleting a Web Message PCS Software Modem Install Help For Windows 98SE, click Add under the General tab see Figure Install New Modem Windows 98SE Section Digital Signature Not Found Adding a New Dial-up Connection To configure your RAS dial-up connectionConection Wizard will appear see Figure Click Finish to store the new dial-up connection see Figure Deleting a Dial-up Connection Editing a Dial-up ConnectionConfiguration window contains the following items PCS Connection Card Configuration WindowEnable Sound Alerts Changing Your Roaming SettingsWireless Connection Manager Change Lock Code window will appear see Figure Changing Your Lock CodePCS Connection Card Properties Window General tab see contains the following items Detailed Status Report WindowAbout Wireless Connection Manager Window Wireless Connection Manager Update Wizard will display Updating the Wireless Connection Manager SoftwareSee Figure Page PCS VisionSM Your User Name Accessing the Web With Your PCS Connection CardLaunching the Web To launch the WebMessaging Signing Up for Web UpdatesMenu for a full list of options Using EmailAccessing Email Messages Select Send when your message is ready to be deliveredTo use PCS Business Connection Personal Edition, visit PCS Business ConnectionSM Personal EditionWhen is my data connection active? PCS Vision FAQsPCS Connection Card Troubleshooting TipsHow can I check the quality of my connection? PCS Connection Card FAQsCard is not responding properly Troubleshooting Error MessagesContact PCS Customer Service Solutions at 1-888-211-4PCS Product Specifications Environmental Specifications Technical SpecificationsThis product was manufactured under the US patent Wireless Connection Manager Software Safety and RegulationsDriver or operator of any vehicles should not operate Safety and HazardsImportant Notice PCS Connection Card to transmit or receive such dataFCC ID PKRNVWC201 Regulatory NoticesSafety and Regulations Terms and Conditions Warranty Information Terms and Conditions of Services We may change this Agreement at any time You must be at least PCS Vision Third Generation Wireless Charges. For PCS Vision If you initiate and complete another call without leaving PCS Voice Command feature begin when you press or activateTerms and Conditions & Warranty Information Terms and Conditions & Warranty Information If you are on a Non-Term Terms and Conditions & Warranty Information Terms and Conditions & Warranty Information Terms and Conditions & Warranty Information Terms and Conditions & Warranty Information We may give credit for a continuous Terms and Conditions & Warranty Information Terms and Conditions & Warranty Information Mandatory Arbitration of DISPUTES. ANY Claim You may notify us by calling PCS Customer Service Solutions, Terms and Conditions & Warranty Information Manufacturer’s Warranty Terms and Conditions & Warranty Information Page Index Index