Note: If you are using the defaults for the Raven X and the
Gateway, you can skip this section and connect your
Gateway directly to your Raven X.
Configuring the Raven X
1.Connect your Raven X directly to the Ethernet port on your computer and to power.
2.Start Wireless Ace and connect to your modem.
Start > All Programs > AirLink Communications > Wireless
Ace 3G > Wireless Ace 3G
a.Click on Connect.
b.Select UDP.
c.Type in the modem’s local IP (default is 192.168.13.31).
d.Type in the modem’s password (default 12345)
Figure 2-1: Wireless Ace : Connexion Connect
3.Select Common > PPP/Ethernet from the menu on the left side of Wireless Ace (under “Groups”).
Configure the Raven X for Public Mode. Set the *HOSTPRIVMODE to 0. In this mode, the modem assigns the RJ‐11 IP Gateway the IP address it has received from your cellular provider. This is the default setting for the modem.
0 - Use Public IP
|
|
|
|
|
|
|
Rev 3.0 B 2/15/08 |
|
|
|
|
| 7 |
|
|
|