Sierra Wireless MP215 manual AT Commands, Command WS181

Page 37

MP215 Mobile Modem

Installation, Configuration, and User’s Guide

Legend:

Command

WS181

Notes, Exception

AT Commands

The AT command

The required state of WS181 register (defines the operational mode). If blank, it means don’t care or not applicable. Otherwise an ERROR response will result if WS181 is not in the specified state.

Special notes, including how the command executes. “Not supported” means the command will return an ERROR response.

Command

WS181

Notes, Exceptions

A

 

Not supported

D

 

Enters SLIP state. Dial numbers and

 

 

modifiers ignored. Enables auto-select and

 

 

auto-registration operations

Fn

 

Not supported

Hn

 

Value ignored.

In

 

I5 reports Processor Board firmware date-rev

 

 

string

 

 

I7 reports “C”

 

 

I8 reports MP210 ATI5 response

On

 

Exactly same as command ATD

Zn

0

Reloads current Novram defaults for this

 

 

mode.

Zn

1

Reloads current Novram defaults for this

 

 

mode.

Zn

3

Reloads current Novram defaults for current

 

 

mode as per 0,1 above.

&Cn

 

Not supported. &C1 is implicit default

&Dn

 

&D1 not supported. &D0 and &D2

 

 

supported as expected.

&Fn

0

Reloads factory defaults <n> for this mode

&Fn

1

Reloads factory defaults <n> for this mode

&Fn

3

Not supported

&In

 

Not supported

&Kn

 

Not supported. &K3 is implicit default.

&Rn

 

Not supported

&Sn

 

Not supported

&W

0

Saves current settings for this mode.

&W

1

Saves current settings for this mode.

&W

3

Not supported.

PN 2110036 Revision 1.0

05/11/99

9-3

Image 37
Contents MP215 Modem Page Important Notice Regulatory Information Customer Service Contents Operating the MP215 via Watcher Figures Tables Page CS-CDPD OverviewMP215 Operating Modes MP215 Host Interface MP215 Wireless Expert and WatcherInstalling the Modem in a Vehicle MP215 InstallationInstalling the Cellular Antenna Connecting the Serial CableWarranty Registration Host interface External InterfacesDB-9 Female Power Supply Interface and On/Off ControlPower Connector Pin-out cable side Speaker Modem Status IndicatorRF Antenna Connector I/O ConnectorMating Connector Suggestions Speaker SuggestionsSierra Wireless Inc 05/11/99 Installing MP215 Firmware Installing MP215 Firmware and Utility SoftwareInstalling Wireless Expert and Watcher Software Setup Configuring the MP215 With Wireless ExpertAmps Provisioning Cdpd provisioning Programming the Dial CodeNEI and Side Preference DNS Configuration Configuring the MP215 for CSC mode Configuring the MP215 via AT CommandsProgramming the NAM Programming the CS-CDPD Modem Bank Dial CodeMaxidle Timer Autoswitch ProvisioningAutocheck Timer Programming the Channel Side PreferenceMaxcdpdlost Timer Maxcdpdscan TimerCDPDPresence Timer Page CS-CDPD Operating the MP215 via WatcherSierra Wireless, Inc 05/11/99 Operating the MP215 via AT Commands Page General Description Host InterfaceAT Command Specifics Command WS181 AT CommandsRegisters and +WS registers +WPREG