5: Configuring the Router Functions
• |
| |
• NAT mode | This chapter describes the router functions of the MP modem | |
• MP modem networking | ||
and shows you how to configure the MP modem to use its | ||
basics in NAT mode | router capabilities. | |
• Static IP and TCP/ | The MP modem supports Network Address Translation | |
UDP port forwarding | ||
(NAT). NAT operation enables you to use the MP modem to | ||
in NAT mode | communicate with up to 10 devices on an Ethernet network | |
| and up to 10 additional devices on a wireless access point | |
| network. | |
| The following table summarizes the MP modem’s non‐NAT | |
| and NAT modes. |
Factor | NAT mode | |
|
|
|
Number of devices | One | Up to 10 over Ethernet and |
supported |
| another 10 over WAP |
|
| simultaneously |
|
|
|
VPN supported | Yes | IPSec |
|
| PPTP from R2.0.2 |
|
|
|
Interfaces supported | Serial | Ethernet |
| USB (laptop only) | Wireless access point (WAP)a |
| Ethernet |
|
| Wireless access point (WAP)a |
|
a. Note: Watcher is not available when using the WAP interface.
|
|
|
|
|
|
|
Rev 1.5 Jul.08 |
|
|
|
|
| 49 |
|
|
|