Procom CGA7740N manual Via the PBC method, Via the Manual configuration

Page 9

3.4.2 via the PBC method

1Check that your Wireless router and that the other WPS device are connected and ON

2Push and hold the WPS button, located on the front side on your router, for 3 seconds

3Push and hold the WPS button of the other WPS device for 3 seconds (refer to the manual of the other WPS device for location)

• The other WPS device is installed on your network

OR

1Check that your Wireless router and that the other WPS device are connected and ON

2On your Internet Browser, enter http://192.168.2.1 in the address field and click on GO to access the webpages

3Click on the WIRELESS tab on the left side of the page and select PBC to open the corresponding subpage

4Click on START PBC

• The other WPS device is installed on your network

Note

The push and hold procedure on the two WPS buttons (router and other WPS device) has to be done within a two minutes’ interval.

3.4.3 via the Manual configuration

This method enables you to configure client devices without WPS function.

1On your Internet Browser, enter http://192.168.2.1 in the address field and click on GO to access the webpages

2Click on the WIRELESS tab on the left side of the page and select Manual to open the corresponding subpage

3Take note of the settings displayed and configure your non-WPS device accordingly

• Your non-WPS device is installed on your network

Getting started

7

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Register your product and get support at CGA7740N Page Table of contents Network range & speed information Safety informationConformity Use one of the following disposal optionsYour Wireless Adsl Modem Router What’s in the boxWhat else will you need Power Inlet Reset buttonButton Adsl portGetting started InstallConnect TipInstall a Wireless USB adapter CCU7740N Install a WiFi deviceInstall another WiFi device Install another WPS deviceVia the PBC method Via the Manual configurationConfiguring the Wireless Modem Router ISP settings 4 DNS ParametersSecurity webpages Firewall Access Control URL Blocking MAC filterSchedule Rule Intrusion Detection Wireless SecurityAccess Control Wireless Encryption802.1x 3 WPSNetwork settings Home Network Settings webpages StatusWireless ManualChannel and Ssid Advanced settings webpages1 NAT Virtual ServerConfiguration Tools Firmware Upgrade Reset MaintenanceSpecial Applications NAT Mapping TablePassword Settings Remote Management System Time SettingsSnmp Snmp communityDdns Ddns Dynamic DNS settings Upnp Upnp Universal Plug and Play settingsSnmp Trap Traffic Mapping QoSWireless settings Static route SET UP WiZARD Getting startedRouting RIP parametersConfirm Adsl settingsAdsl Features Technical dataFrequently asked questions Page
Top Page Image Contents