RAD Data comm ASM-10/8 operation manual Installation and Setup, Setting, Internal Jumpers

Warning

Caution

1.Open the ASM-10/8 case.

2.Set the ASM-10/8 internal jumpers and switches, referring to Figure 2-1.

3.Reinstall the ASM-10/8 cover.

Access to the inside of the equipment is permitted only to the authorized and qualified personnel.

To avoid accidental electric shock, always disconnect the interface cables and the power cord before removing the unit from its casing.

Line voltages are present inside ASM-10/8 when it is connected to power and/or the lines. Moreover, under certain fault conditions, dangerous voltages may appear on the lines connected to the unit.

Any adjustment, maintenance and repair of the opened instrument under voltage must be avoided as much as possible and, when inevitable, should be carried out only by a skilled technician who is aware of the hazard involved. Capacitors inside the unit may still be charged even after the unit has been disconnected from its source of power.

ASM-10/8 contains components sensitive to electrostatic discharge (ESD). To prevent ESD damage, avoid touching the internal components, and before moving jumpers, touch the ASM-10/8 frame.