GBC 4064WF-1 operation manual FEATURES/ACCESORIES Guide, Emergency Stop Buttons Figure A, Item

GBC 4064WF-1

FEATURES/ACCESORIES GUIDE

Refer to the following pages for detailed information on the

Features

FIGURE A

1. Emergency Stop Buttons: (FIGURE A, Item 1)

Four E-Stop buttons are on the Laminator located on the top of the Laminator at all four corners.

To Engage E-Stop buttons, press any E-Stop Safety Push button to stop the roller movement.

To disengage turn the push button clockwise when the emergency condition has been resolved.

FIGURE B

1. Heated Main Top Roller: (FIGURE B, Item 1)

Silicone rubber coated steel tube heat the laminating film and compress the heated film to the items being laminated. Heat is provided by an internal heating element.

2.Heated Main Bottom Roller: (FIGURE B, Item 2) Silicone rubber coated steel tube heat the laminating film and compress the heated film to the items being laminated. Heat is provided by an internal heating element.

3.Media Pressure Plate: (FIGURE B, Item 3)

The Pressure Plate mounted to the front of the table helps hold down the image as it enters the Nip Area. To remove, move Spring Pin, and remove Pressure Plate.

FIGURE C

1. Front Table: (FIGURE C, Item 1)

The Front Table aids the operator when aligning media. The Front Table is stationary but pivots down for easy access to the film. To pivot the table down, lift up on the Media idler (FIGURE C, Item

2)and pull the table towards you. The table can now pivot down. Note: The machine is limited to 3ft/min while either table is in the down position.

Operation Manual

2 Table Idler: (FIGURE C, Item 2)

The Table Idler assists feeding of images into the web. It is helpful in roll to roll operation and helps move large rigid panels through the nip.

FIGURE D

1. Safety Light Beam System: (FIGURE D, Item 1)

The 4064WF-1 uses a Safety Light Beam to protect the end-user from harm. When this Beam is blocked, the Rollers will stop rotating. Once the Beam is interrupted, the operator must re-start the machine by pressing Run. There are 2 sets of Safety Light Beams. One set in the front, one set in the rear. (See Sequence of Operation Chart for detail sequence of the Safety Beam. Diagram 1 Page 11)

FIGURE E

1. Rewinder Tubes: (FIGURE E, Item 1)

Used to rewind release liners or finished Medias.

2. Upper Tension Idler Bar: (FIGURE E, Item 2)

The Upper Tension Idler Guides the upper lamination onto the Top Main Roller insuring a constant amount of wrap on the Top Main Roller.

FIGURE F

1. Rewinder Clutch Adjustment: (FIGURE F, Item 1)

The 4064WF-1 has Rewinder Tubes that will take-up release liners and rewind finished product. By rotating the gnarled disk (FIGURE F, Item 1) Counter Clockwise, the take up action will increase. Counter Clockwise will reduce the effect.

2. Nip Pressure: (FIGURE F, Item 2)

The 4064WF-1 uses pneumatics to operate the Main Rollers and Pull Rollers. You can adjust the amount of PSI that is desired on the Main Rollers and Pull Rolls by rotating the Pneumatic Adjustment Knob (FIGURE F, Item 3). To increase PSI, rotate the knob cock-wise. To reduce the amount of PSI, turn the knob counter clock-wise.

3. Pneumatic Adjustment Knob: (FIGURE F, Item 3)

© 2009 GBC an ACCO Brands Co. Page 13