GBC | Operation Manual |
Start Laminating
1.At this point you should have your laminator webbed with the appropriate material for your application.
2.The feed table should be in the normal operating position.
3.Close the main and Pull roll nips. Rollers should be closed.
4.Speed is set to 3 or less and front () motor direction is selected.
5.Press the start (
) button.
6.Set main roller pressure between 40% – 60% for laminating by turning the main roll lift handle.
CAUTION: If using PSA film, an air pocket may form between the main rollers and pull rollers. Raise the pull rollers to allow the air Pocket to pass.
7.Make any necessary film brake tension adjustments, pull/main roller pressure, and clutch and/ or rewind brake tension adjustments.
8.Position the item to be laminated on the feed table.
9.Align the leading edge of the item parallel to the heat roller nip (Fig. 25).
10.Use both hands to force the image outward and slowly push inwardtoward the nip of the heat rollers (Fig. 26).
CAUTION: Avoid forcing the image into the main roller nip as this action will cause the corners of the leading edge to buckle and create a wave.
FIGURE 25
FIGURE 26
© 2009 GBC an ACCO Brands Co. | Page 20 |