GBC 4064WF-1 operation manual Figure G

GBC 4064WF-1

To increase PSI, rotate the knob cock-wise. To reduce the amount of PSI, turn the knob counter clock-wise.

FIGURE G

1. Main Air Supply: (FIGURE G, Item 1)

The 4064WF-1 requires Compressed Air. Connect to the Main Air Supply at #1.

FIGURE H

1 & 3. Swing -Out Film Unwind Shaft Brake Tension Knob: (FIGURE H, Item 1 & 3)

The Swing-out Film Shaft is used to provide tension to match materials going into the laminated rollers. To increase tension, rotate the knob clock-wise. To reduce tension, rotate the knob counter clock-wise

2 & 4. Swing -Out Film Unwind Shaft: (FIGURE H, Item 2 &4)

The Swing-out Film Shaft is used to provide tension to match material when holding media and materials.

5. Core Chucks: (FIGURE H, Item 5)

Bi-Directional Core Chucks grip the Medias supply tube. Our patented roller core chuck will allow the operator the ability to add or remove film with ease.

FIGURE I

1. Upper Pull Roll: (FIGURE I, Item 1)

The Pull rollers located at the back of the laminator are motor driven. They simultaneously pull the film and image. The Upper Pull Roller (FIGURE I, Item 1) can be Raised and Lowered via the Main Control Panel.

Operation Manual

2. Lower Pull Roll: (FIGURE I, Item 2)

The Pull rollers located at the back of the laminator are motor driven. They simultaneously pull the film and image. The Lower Pull Roller is clutched.

3. Rear Table: (FIGURE I, Item 3)

Used to support finished Media and used when running the machine from the rear.

4.Rear Table Safety Interlock Switch: (FIGURE I, Item 4) The Rear Table Safety Switch ensures that the Rear Table is inserted properly and if not engaged, the machine will only operate with the foot switch at 3ft/mn.

FIGURE J

1. Rear Slitter: (FIGURE J, Item 1)

The Rear Slitter is used for slitting Media after lamination. Press down on the Slitter Assy’ (FIGURE J, Item 1) to engage the slitter.

2. Rear Slitter Track Assy’: (FIGURE J, Item 2)

The Rear Slitter Track Assy’ allows the Slitter Assy’ to travel the length of the Rear Table.

3. Rear Table Media Idler: (FIGURE J, Item 3)

Used for guiding Media through the laminator. The table Idler is helpful in roll to roll operation and helps move large ridged panels through the nip.

FIGURE K

1. In-Line Slitters: (FIGURE K, Item 1)

The In-Line Slitters allows the operator to slit images as they pass through the Main Rollers and into the Pull rollers. The trimmed waste can then be attached to the Rewinder Tubes and disposed of later.

2. Slitter Blade Switch: (FIGURE K, Item 2)

The Slitter Blade can be engaged by pressing down carefully on the Blade Switch. To disengage, carefully pull up on the Slitter Blade Switch.

3.In-Line Slitter Bar Mounting Lever: (FIGURE K, Item 3) The In-Line Slitters bar mounting Lever Allows the operator to remove the Slitter Bar Assy’ or position it to the desired location.

4.In-Line Slitters Cutting Position: (FIGURE K, Item 4)

To lower the position of the In-Line Slitter Bar, release the Lever and relocate to the position shown in FIGURE K Item 4.