Newcon Optik LAM 10M IR Operation Instructions, Installing the battery, Mounting LAM on a weapon

Page 13

5.OPERATION INSTRUCTIONS

5.1. Installing the battery

LAM is powered by a standard Lithium CR123 3V battery. To install a battery:

-unscrew the battery compartment cap (15, Fig.1),

-insert a battery observing the polarity as marked on the battery compartment,

-check the condition of the O-ring on the body; replace it if worn or torn,

-screw the battery compartment cap back on.

5.2. Mounting LAM on a weapon

LAM is mounted on a Picatinny rail in the following order:

-loosen screw caps (13, Fig.1),

-align LAM on Picatinny rail,

-fasten the screw caps (13, Fig.1).

Note: The distance between the gas exit nozzles of the rifle and laser beam output window should be as long as possible so that the window would remain clean during shooting.

10

Page 12 Page 14
Image 13
Page 12 Page 14
Contents LAM 10M IR Laser Aiming Module Target Pointer Page Read prior to activation Important InformationContents Brief description Device design LAM 10M IR OFF ModePage Remote switch Standard delivery set Delivery SETSpecifications Operation Instructions Installing the batteryMounting LAM on a weapon Adjusting LAM on a weapon Connecting the remote control To connect the remote switchPage General Maintenance, storage and transportationTo remove old layer of lubricant StorageTransportation To apply new layer of lubricantPage Spot shape or size has changed TroubleshootingWhat This Warranty Does Not Cover WarrantyCustomer Support Quality Certificate Newcon Optik
Top Page Image Contents