Newcon Optik LAM 10M IR operation manual Troubleshooting, Spot shape or size has changed

Page 20

7.TROUBLESHOOTING

Spot shape or size has changed

Emitter objective lens is dirty. Flush emitter lens with fresh water and wipe it with soft cloth.

No radiation when activating LAM with remote switch

Turn the operating modes switch (17, Fig.1) to OFF position and then turn LAM ON again. If this doesn’t help, replace the remote switch.

Radiation doesn’t stop when remote switch is released

Replace the remote switch.

Moisture in the battery compartment.

Check the O-ring on the battery compartment cover and replace it if necessary.

Shift of zero line when firing

Tighten screw caps (13, Fig.1) on the Picatinny rail.

17

Image 20

Contents LAM 10M IR Laser Aiming Module Target Pointer Page Important Information Read prior to activationContents Brief description Device design LAM 10M IR Mode OFFPage Remote switch Delivery SET Standard delivery setSpecifications Mounting LAM on a weapon Installing the batteryOperation Instructions Connecting the remote control To connect the remote switch Adjusting LAM on a weaponPage Maintenance, storage and transportation GeneralStorage To remove old layer of lubricantTo apply new layer of lubricant TransportationPage Troubleshooting Spot shape or size has changedWarranty What This Warranty Does Not CoverCustomer Support Quality Certificate Newcon Optik