Emotiva UPA-1, UPA-5 manual UPA‐7

Page 33

UPA‐7

Number of Channels: 7

Topology: Fully Discrete, Dual Differential, High Current, Short Signal Path Class A/B

Power output (all channels driven): 185 watts RMS @ 4 ohm (0.1% THD) 125 watts RMS @ 8 ohm (0.1% THD)

Power Band Response: 20 Hz to 20 kHz with less than .05db deviation at rated power

Broadband Frequency Response: (‐3db): 5Hz to 150kHz

Amplifier Gain: 32db

Signal to Noise Ratio

1 watt: >115db

Full Power: >120db

Input Impedance: 23.5kohms

Transformer Size: 850VA

Secondary Capacitance: 90,000uF

Output Devices: 4 per channel

Size: 17” W x 7.75” H x 19” D

Weight: 66 lbs (84 lbs boxed)

33

Image 33

Contents Page Page SAFETY PRECAUTIONS TECHNICAL SPECIFICATIONS Troubleshooting GuideLimited Warranty Service AssistanceSafety Precautions WIDE SLOT, FULLY INSERT Antenna Grounding Outside the House NEC National Electrical Code StandardsDan Laufman Thank You for your PurchaseUPA‐1 Ultra Series Amplifiers OverviewUPA‐2 UPA‐5 and UPA‐7Power Rating Note ‘Peak’ vs. ‘Continuous’ Ultra Series Amplifier FeaturesInventory Unpacking Your Ultra Amplifier2.Front Panel Power Switch Front Panel Layout1.Front Panel LED Display Note On Amplifier SupportsBack Panel Layouts UPA‐1 Back Panel 10.IEC Power Cable Connection UPA‐2 Back Panel 10.IEC Power Cable Connection 2.Channel Five Audio Input UPA‐5 Back Panel3.Channel Four Audio Input 4.Channel Three Audio Input9.Channel Five Speaker Terminals 14.IEC Power Cable Connection10.Channel Four Speaker Terminals 11.Channel Three Speaker Terminals2.Channel Seven Audio Input UPA‐7 Back Panel3.Channel Six Audio Input 4.Channel Five Audio Input11.Channel Seven Speaker Terminals Installation and Connections AC Power ConsiderationsPhysical Placement /Heat Considerations Input Connection Considerations Output Connection ConsiderationsConnection Tips for Superior Sound Connection Diagram using a UPA‐7 for example Page Series Connection Series and Parallel Speaker ConnectionsTechnical Note about Multiple Speaker Connections Parallel ConnectionsTroubleshooting Guide Poor Bass Performance from Full Range Speakers Turn‐on and Turn‐off Thumps“Hum” Noises in the Speakers A fault condition is one or more of the following Problems with the whole A/V SystemOther Probable Causes of Noise TECHNICAL SPECIFICATIONS UPA‐1 UPA‐2 UPA‐5 UPA‐7 Limited Warranty Service AssistanceReference - Put you RMA number in this spot Emotiva Disclosure