Emotiva UPA-5, UPA-1 manual TECHNICAL SPECIFICATIONS UPA‐1

Page 30

TECHNICAL SPECIFICATIONS:

UPA‐1

Number of Channels: 1

Topology: Fully Discrete, Dual Differential, High Current, Short Signal Path Class A/B

Power output (all channels driven): 350 watts RMS @ 4 ohm (0.1% THD) 200 watts RMS @ 8 ohm (0.1% THD)

Power Band Response: 20 Hz to 20 kHz with less than .05db deviation at rated power

Broadband Frequency Response: (‐3db): 5Hz to 150kHz

Amplifier Gain: 32db

Signal to Noise Ratio

1 watt: >89db

Full Power: >117db

Input Impedance:

Unbalanced – 23.5kohms

Balanced – 33kohms

Transformer Size: 300VA

Secondary capacitance: 80,000uF

Output Devices: 6

Size: 17” W x 3.875” H x 18” D

Weight: 26 lbs (35 lbs boxed)

continued, next page

30

Image 30

Contents Page Page SAFETY PRECAUTIONS Limited Warranty Troubleshooting GuideTECHNICAL SPECIFICATIONS Service AssistanceSafety Precautions WIDE SLOT, FULLY INSERT NEC National Electrical Code Standards Antenna Grounding Outside the HouseThank You for your Purchase Dan LaufmanUPA‐2 Ultra Series Amplifiers OverviewUPA‐1 UPA‐5 and UPA‐7Ultra Series Amplifier Features Power Rating Note ‘Peak’ vs. ‘Continuous’Unpacking Your Ultra Amplifier Inventory1.Front Panel LED Display Front Panel Layout2.Front Panel Power Switch Note On Amplifier SupportsBack Panel Layouts UPA‐1 Back Panel 10.IEC Power Cable Connection UPA‐2 Back Panel 10.IEC Power Cable Connection 3.Channel Four Audio Input UPA‐5 Back Panel2.Channel Five Audio Input 4.Channel Three Audio Input10.Channel Four Speaker Terminals 14.IEC Power Cable Connection9.Channel Five Speaker Terminals 11.Channel Three Speaker Terminals3.Channel Six Audio Input UPA‐7 Back Panel2.Channel Seven Audio Input 4.Channel Five Audio Input11.Channel Seven Speaker Terminals Installation and Connections AC Power ConsiderationsPhysical Placement /Heat Considerations Input Connection Considerations Output Connection ConsiderationsConnection Tips for Superior Sound Connection Diagram using a UPA‐7 for example Page Series and Parallel Speaker Connections Series ConnectionParallel Connections Technical Note about Multiple Speaker ConnectionsTroubleshooting Guide Poor Bass Performance from Full Range Speakers Turn‐on and Turn‐off Thumps“Hum” Noises in the Speakers A fault condition is one or more of the following Problems with the whole A/V SystemOther Probable Causes of Noise TECHNICAL SPECIFICATIONS UPA‐1 UPA‐2 UPA‐5 UPA‐7 Limited Warranty Service AssistanceReference - Put you RMA number in this spot Emotiva Disclosure