Poor Bass Performance from Full Range Speakers

•Make sure that your preamp does not have the bass (tone control) level turned down.

•Many surround preamplifiers have controls, which can direct all the bass to subwoofers, or let your main speakers play the full range. Make sure that the preamplifier has been correctly set. If you are not using a subwoofer, set the speaker options to “Large” where possible.

•Check that the speaker wires have been connected correctly: Make sure that the positive of each speaker connects to a positive output of the amplifier, and the negative of each speaker connects to the negative output. If one speaker is wired incorrectly, then it will be “out of phase” with the others, resulting in poor bass performance.

DOUBLE CHECK ALL THE SPEAKER CONNECTIONS!!

Turn‐on and Turn‐off Thumps

•Plug the ampliﬁer into an un‐switched AC outlet, and use the 3.5mm Trigger Input connection with a trigger between 5‐12VDC from the source unit or preampliﬁer. This should allow the ampliﬁer to turn on and off silently.

•If your powered subwoofer is the cause of the “thump” sound (not the other speakers connected to the amplifier), plug it into a different 115VAC outlet than the ampliﬁer so there is no power surge conﬂict.

•Install a line‐conditioning device.

“Hum” Noises in the Speakers

•This problem is more than likely caused by a “ground loop” in your system, rather than a fault in the amplifier. Follow these steps to isolate the main cause of the hum; there may even be more than one. Remember to turn off all components in your system, including the ampliﬁer, before disconnecting or connecting any cables during troubleshooting.

•Try to have all of your equipment on the same electrical outlet or circuit. Group all the low power components (preamp, CD player, DVD etc.) on a single outlet or power strip. This is provided that the overall current draw from your equipment does not exceed the rating of the outlet or breaker.

•Disconnect all cables, which come from outside the room, and check if the hum goes away. This includes such connections as cable TV, satellite TV, or roof top antennas. Make sure that they are disconnected where they ﬁrst enter the room, so they are making no connection to the preamplifier or the TV, or any other component. If the hum is caused by the cable TV line, then you will need a “ground loop isolator.” This is an inexpensive device ﬁtted in line with the coaxial cable feed. Contact your Cable Company or Emotiva for assistance.

•Disconnect all connections from the preampliﬁer to your TV, VCR or DVD.

•As a test, disconnect any other component, which has a grounded power cord.

NOTE: Never remove the ground pin from any power cords (if present). This is very dangerous.

If the hum persists, disconnect all the source components one at a time from the back of the preampliﬁer, until you identify the problem.

•Try moving the speaker cables away from any power cords. Try just one speaker, connecting it to each ampliﬁer channel and see if one channel is bad.

Check that the interconnect cables to the ampliﬁer do not have any broken connections. The best way to do this is to substitute a known good connection for the suspect connection. If you reverse the cables and the problem goes away, the cable may be damaged or broken. This is possible even if you can’t physically see the break as the strain for pulling on audio cables can sometimes break the wire internally.