Emotiva UPA-1, UPA-5 manual UPA‐2

Page 31

UPA‐2

Number of Channels: 2

Topology: Fully Discrete, Dual Differential, High Current, Short Signal Path Class A/B

Power output (all channels driven): 185 watts RMS @ 4 ohm (0.1% THD) 125 watts RMS @ 8 ohm (0.1% THD)

Power Band Response: 20 Hz to 20 kHz with less than .05db deviation at rated power

Broadband Frequency Response: (‐3db): 5Hz to 150kHz

Amplifier Gain: 32db

Signal to Noise Ratio

1 watt: >93db

Full Power: >107db

Input Impedance: 25kohms

Transformer Size: 300VA

Secondary capacitance: 40,000uF

Output Devices: 4 per channel

Size: 17” W x 3.875” H x 18” D

Weight: 30 lbs (39 lbs boxed)

continued, next page

31

Image 31

Contents Page Page SAFETY PRECAUTIONS Service Assistance Troubleshooting GuideTECHNICAL SPECIFICATIONS Limited WarrantySafety Precautions WIDE SLOT, FULLY INSERT Antenna Grounding Outside the House NEC National Electrical Code StandardsDan Laufman Thank You for your PurchaseUPA‐5 and UPA‐7 Ultra Series Amplifiers OverviewUPA‐1 UPA‐2Power Rating Note ‘Peak’ vs. ‘Continuous’ Ultra Series Amplifier FeaturesInventory Unpacking Your Ultra AmplifierNote On Amplifier Supports Front Panel Layout2.Front Panel Power Switch 1.Front Panel LED DisplayBack Panel Layouts UPA‐1 Back Panel 10.IEC Power Cable Connection UPA‐2 Back Panel 10.IEC Power Cable Connection 4.Channel Three Audio Input UPA‐5 Back Panel2.Channel Five Audio Input 3.Channel Four Audio Input11.Channel Three Speaker Terminals 14.IEC Power Cable Connection9.Channel Five Speaker Terminals 10.Channel Four Speaker Terminals4.Channel Five Audio Input UPA‐7 Back Panel2.Channel Seven Audio Input 3.Channel Six Audio Input11.Channel Seven Speaker Terminals AC Power Considerations Installation and ConnectionsPhysical Placement /Heat Considerations Output Connection Considerations Input Connection ConsiderationsConnection Tips for Superior Sound Connection Diagram using a UPA‐7 for example Page Series Connection Series and Parallel Speaker ConnectionsTechnical Note about Multiple Speaker Connections Parallel ConnectionsTroubleshooting Guide Turn‐on and Turn‐off Thumps Poor Bass Performance from Full Range Speakers“Hum” Noises in the Speakers Problems with the whole A/V System A fault condition is one or more of the followingOther Probable Causes of Noise TECHNICAL SPECIFICATIONS UPA‐1 UPA‐2 UPA‐5 UPA‐7 Service Assistance Limited WarrantyReference - Put you RMA number in this spot Emotiva Disclosure