CARE AND CLEANING
6.Take out all removable parts, wrap them well and tape together so they don’t shift and rattle during the move. Refer to sections in Using your Refrigerator for removal instructions.
7.Depending on the model, raise the front of the refrigerator so it rolls more easily OR screw in the leveling legs all the way so they don’t scrape the floor. See the DOOR ALIGNMENT section.
8.Tape the doors shut and tape the power cord to the refrigerator cabinet.
When you get to your new home, put everything back and refer to the REFRIGERATION INSTALLATION section for setup instructions.
OPERATION INSTRUCTIONS
WARNING
Personal Injury Hazard
Avoid contact with the moving parts of the ejector mechanism, or with the heating element that releases the cubes. DO NOT place fingers or hands on the automatic icemaking mechanism while the refrigerator is plugged in.
A newly-installed refrigerator may take
12 to 24 hours to begin making ice.
Power Switch
ON/OFF
Feeler Arm
The icemaker will produce 8 cubes per cycle, approximately
If the refrigerator is used before the water connection is made to the icemaker, set the power switch to OFF.
When the refrigerator has been connected to the water supply, set the power switch to ON.
The icemaker will fill with water when it cools to freezing. A
Throw away the first few batches of ice to allow the water line to clear.
Be sure nothing interferes with the sweep of the feeler arm.
When the bin fills to the level of the feeler arm, the icemaker will stop producing ice.
It is normal for several cubes to be stuck together .
If ice is not used frequently, old ice cubes will become cloudy, taste stale, and shrink.
WHEN YOU SHOULD SET THE ICEMAKER POWER SWITCH TO (OFF)
When the water supply will be shut off for several hours.
When the ice storage bin is removed for more than a minute or two.
When the refrigerator will not be used for several days.
NORMAL SOUNDS YOU MAY HEAR
The icemaker water valve will buzz as the icemaker fills with water. If the power switch is in the ON position, it will buzz even if it has not yet been hooked up to water. To stop the buzzing, move the power switch to OFF position.
NOTE: Keep the power switch in the ON position before the water line is connected can damage the icemaker.
You will hear the sound of cubes dropping into the bin and water running in the pipes as the icemaker refills.
21