CONNECTING THE WATER LINE
8. FLUSH OUT THE TUBING
Turn the main water supply on and flush out the tubing until the water is clear.
Shut the water off at the water valve after about one quart of gallon of water has been flushed through the tubing.
9.CONNECT THE TUBING TO THE REFRIGERATOR
NOTES:
1
Tubing Clamp
1/4" (6.35 mm) Compression Nut
2
Ferrule (Sleeve)
1/4" (6.35 mm) Tubing
Refrigerator
Connection
Before making the connection to the refrigerator, be sure the refrigerator power cord is not plugged into the wall outlet.
If your refrigerator does not have a water filter, we recommend installing one. If your water supply has sand or particles that could clog the screen of the refrigerator’s water valve. Install the filter in the water line near the refrigerator
Do not uses old hoses, only uses new hoses provided by the manufacturer.
1.Remove the plastic flexible cap from the refrigerator connection.
2.Place the compression nut and ferrule (sleeve) onto the end of the tubing.
3.Insert the end of the tubing into the connection as far as possible. While holding the tubing, tighten the fitting.
CAUTION: Review not occuring leakage in the water line.
Fasten the tubing into the tubing Clamp attached to the back of the refrigerator.
First, loosen the screw fastening the clamp. Next, insert the tubing in the groove. Finally,
10. TURN THE WATER ON AT THE SHUTOFF VALVE
Tighten any connections that leak.
Reattach the compressor compartment access cover.
11. PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate against the back of the refrigerator or against the wall. Push the refrigerator back to the wall.
12. START THE ICE MAKER
Set the icemaker power switch to the ON position. The icemaker will not begin to operate until it Reaches its operating temperature of 15 °F
24
