USP-1 Rear Panel Layout, Trigger Output

USP-1 Rear Panel Layout

(for larger image, see page 25)

1. TRIGGER OUTPUT

Allows a mono to mono 3.5mm cable to remotely trigger another device on and off, along with the USP-

1.Current is limited to 500mA, which is sufficient to trigger two devices. For triggering more devices, you may want to use a separate triggering device, like the Emotiva ET-3.

2.PHONO INPUT Section (clockwise from top left)

•Phono Ground

•Left and Right channel RCA inputs

•MC/MM Switch. Use this switch to select your cartridge type. MC for Moving Coil or MM for Moving Magnet.

3.AUDIO Section (from left to right)

•CD player inputs

•Tuner inputs

•Auxiliary 1 inputs – Suitable to connect to any audio device with Left and Right analog outputs.

•Auxiliary 2 inputs – Suitable to connect to any audio device with Left and Right analog outputs.

4.TAPE INPUT/OUTPUT

A tape loop is provided for recording 2-channel source material from a Cassette, DAT or a Hard Disk Audio device with analog outputs.

5.HT INPUT (Home Theater)

Allows the USP-1 to connect to an external multi-channel/home theater processor. This connection is disengaged when the USP-1 is in normal mode, but becomes active when the HT BYPASS button is selected on either the USP-1 front panel or remote control. In HT BYPASS mode, this connection becomes active and the USP-1 becomes a pass-through for the left, right, and subwoofer channels. This is a true ‘straight wire’ pass-through – what comes in is what goes out. This signal is sent into the HT Inputs (L,R, Sub), and is only present on the High Pass and Subwoofer Outputs.

NOTE: HT INPUTS are only active when the USP-1 is on.

ALL USP-1 functions become disabled in HT BYPASS mode, allowing the external processor to control volume, EQ, etc.