USP-1 Remote

The USP-1 has a dedicated remote control that offers discrete buttons for most of the critical USP-1 controls.

Power Buttons

Discrete buttons to turn the USP-1 on and off, as indicated.

Volume Controls

Applies continuous increase (+) or decrease (-) in volume levels while buttons are held down. The USP-1 volume knob moves in correspondence with these controls.

Source Selection Buttons

These buttons select the various source inputs of the USP-1. LED’s on the front panel of the USP-1 will light in correspondence with the selected input

•CD – selects CD player input as source.

•PHONO – selects Phono input as source.

•TUNER – selects Tuner input as source.

•AUX1 – selects Aux1 input as source.

•AUX2 – selects Aux2 input as source.

Mode Buttons

Select the indicated function for the USP-1. Front panel LED’s light in correspondence with the selected mode.

•MONO – switches audio output from stereo to mono. Pressing a second time restores signal to stereo (default).

•TAPE - Push to select the inputs on the Tape Monitor section to pass through the outputs of the tape monitor section. When not selected, any selected input passes through the output of the Tape Monitor output.

•HT (Home Theater Bypass) –When pushed, the HT Input connections will pass through the USP-1, allowing the left channel, right channel and subwoofer to be controlled by a connected multi- channel processor, bypassing the USP-1 completely.

•MUTE - mutes the USP-1.

Changing the Battery

The USP-1 remote is powered by 2 AAA batteries. To add fresh batteries, press in the battery cover tab, remove the battery cover, exchange the batteries and orient the negative and positive ends as

indicated by the images in the battery compartment. Emotiva recommends using alkaline batteries.