KP-43T75A/53SV75A
3-9. ELECTRICAL ADJUSTMENT BY REMOTE
COMMANDER
By using Remote Commander
can be made.
NOTE : Test Equipment Required.
1.Pattern Generator (with component outputs)
2.Frequency counter
3.Digital multimeter
4.Audio oscillator
1. METHOD OF SETTINGTHE SERVICE ADJUSTMENT MODE
SERVICE MODE PROCEDURE
1. Standby mode. (Power off)
2. DISPLAY n 5 n VOL (+) n TV POWER
on the Remote Commander.
(Press each button within a second.)
7.If you want to recover the latest values press
8.Press [MUTING] then [ENTER] to write into memory.
9.Turn power off.
Note: Press 8then [ENTER] on the Remote Commander to initialize or turn set off and on to exit.
2. MEMORY WRITE CONFIRMATION METHOD
1.After adjustment, remove the plug from AC outlet, and then replace the plug in AC outlet again.
2.Turn the power switch ON and set to Service Mode.
3.Call the adjusted items again and confirm they were adjusted.
3. ADJUSTING BUTTONS AND INDICATOR
MUTING
SERVICE MODE ADJUSTMENT
MUTING DVD/ | SAT/ POWER |
VTR | CABLE |
| TV |
TV POWER ON
Category | Adjustment item | |
|
| DATA |
SERVICE VP50 00 VPOS 040 | ||
000000 | 00 |
|
(SCREEN DISPLAY)
| SYSTEM |
| FUNCTION |
| |
| OFF | DVD/VTR SAT/CABLE | TV | ||
Category up | TV/VTR | FREEZE | SWAP | PIP | |
| m |
| N | M | |
|
| POSITION | AUDIO | ACTIVE | |
| X | z |
| x |
|
|
| SLEEP | ANT | TV/VIDEO | |
| PICTURE | CC | MTS/SAP | DISPLAY | |
| MODE | ||||
Adjustment item up | 1 | 2 | 3 |
DISPLAY
3. | The SCREEN displays the item being adjusted. |
4. | Press 1 or 4on the Remote Commander to select the |
| adjustment item. |
5. | Press 3 or 6on the Remote Commander to change the data. |
6. | Press 2 or 5on the Remote Commander to select the |
| category. |
4 5 6
Adjustment item down
7 8 9
JUMPENTER
0
INDEXGUIDE
RESETMENU
Data up
Data down
Category down
ENTER
Every time you press 2(Category up), Service mode changes |
in the order as shown below. |
VOL (+)
VOL CH
VP50 | SC | CODE SET | |
VP60 | IC |
| |
VPTR | DAC |
| |
VPTV | PI | TV | |
| |||
VPTS | ID |
| |
| |||
PJE | CCD | Note : When the PJE mode is activated, which displays an | |
COM | OP | internally generated signal, several buttons on the remote | |
commander will have different functions than listed | |||
| |||
|
| ||
TONE |
| above. Therefore, when in the PJE mode, refer to page 9 | |
|
| for button functions. |
– 30 –