Dell R610 owner manual 121, Installing and Removing a Memory Module Memory module

Figure 3-18. Installing and Removing a Memory Module

1

2

3

1	memory module	2 memory module socket ejectors (2)
3	alignment key

6Align the memory module's edge connector with the alignment key of the memory module socket, and insert the memory module in the socket.

NOTE: The memory module socket has an alignment key that allows you to install the memory module in the socket in only one way.

7Press down on the memory module with your thumbs to lock the memory module into the socket.

When the memory module is properly seated in the socket, the ejectors on the memory module socket align with the ejectors on the other sockets that have memory modules installed.

8Repeat step 4 through step 7 of this procedure to install the remaining memory modules. See Table 3-3.

9Close the system. See "Closing the System."

10Start up the system, press <F2> to enter the System Setup program, and check the System Memory setting on the main System Setup screen.

The system should have already changed the value to reflect the newly installed memory.

Installing System Components

121