Compatible Systems T1-10/100 manual Shipping Defaults, Ethernet Interface, WAN 0 Interface

Page 15

Chapter 3 - Shipping Defaults

Ethernet Interface

IP Routing Defaults

•On

•Address: 198.41.12.1

•Subnet Mask: 255.255.255.0

•Broadcast Address: 198.41.12.255

•IP RIP off

IPX Routing Defaults

•802.3 on, autoseeding

•802.2 on, autoseeding

•Type II on, nonseeding

•802.2 SNAP on, nonseeding

AppleTalk Routing Defaults

•Phase 1 off

•Phase 2 on, autoseeding

DECnet Defaults

•Off

IP Defaults

•On

•Unnumbered interface

•RIP off

•Van Jacobson compression off

Image 15

Contents Octal T1-10/100 Riop Installation Guide Page Table of Contents Quickstart InstructionsIii LED Patterns Shipping DefaultsIntroduction to the Octal T1-10/100 Riop Network InstallationQuickstart Configuration Shipping DefaultsNetwork Installation Connecting the Octal T1-10/100 to the EthernetConnecting the Octal T1-10/100 to a T1 Line Powering Up the Router Connecting a Management ConsoleRequired for IP Ethernet Interface ConfigurationQuickstart Instructions IP ProtocolIPX Protocol AppleTalk ProtocolDECnet Protocol WAN Link Configuration WAN Interface ConfigurationT1 Physical Communications Settings PPP ConfigurationFrame Relay Configuration Frame Relay Dlci Mappings Required for IP Numbered InterfaceRequired for IP Unnumbered Interface Suggested for IPX Smds Configuration Saving a Configuration File to Flash ROMSmds Addressing Shipping Defaults Ethernet InterfaceWAN 0 Interface WAN 1 7 Interfaces IPX DefaultsAppleTalk Defaults T1 CSU/DSU DefaultsOver Temp General IndicatorsLED Patterns Router LED PatternsT1 Connection Indicators Ethernet Traffic IndicatorsT1 Indicators Ethernet Connection Indicators