Compatible Systems T1-10/100 manual

Page 2

Octal T1-10/100 RIOP Installation Guide, Version 1.0

FCC Notice: This product has been certified to comply with the limits for a Class A computing device, pursuant to Subpart J of Part 15 of FCC Rules. It is designed to provide reasonable protection against radio or television communication interfer- ence in a commercial environment. Operation of this equipment in a residential area could cause interference with radio or television communication.

Image 2

Contents Octal T1-10/100 Riop Installation Guide Page Iii Table of ContentsQuickstart Instructions Shipping Defaults LED PatternsShipping Defaults Network InstallationQuickstart Configuration Introduction to the Octal T1-10/100 RiopConnecting the Octal T1-10/100 to a T1 Line Network InstallationConnecting the Octal T1-10/100 to the Ethernet Connecting a Management Console Powering Up the RouterIP Protocol Ethernet Interface ConfigurationQuickstart Instructions Required for IPDECnet Protocol IPX ProtocolAppleTalk Protocol PPP Configuration WAN Interface ConfigurationT1 Physical Communications Settings WAN Link ConfigurationFrame Relay Configuration Required for IP Unnumbered Interface Frame Relay Dlci MappingsRequired for IP Numbered Interface Suggested for IPX Smds Addressing Smds ConfigurationSaving a Configuration File to Flash ROM WAN 0 Interface Shipping DefaultsEthernet Interface T1 CSU/DSU Defaults IPX DefaultsAppleTalk Defaults WAN 1 7 InterfacesRouter LED Patterns General IndicatorsLED Patterns Over TempEthernet Connection Indicators Ethernet Traffic IndicatorsT1 Indicators T1 Connection Indicators