Compatible Systems T1-10/100 manual WAN 1 7 Interfaces, IPX Defaults, AppleTalk Defaults

Page 16

Chapter 3 - Shipping Defaults

12

IPX Defaults

•On

•Unnumbered interface

AppleTalk Defaults

•On

•Unnumbered interface

DECnet Defaults

•Off

T1 CSU/DSU Defaults

•Full T1

•Slave clock

•B8ZS encoding

•ESF framing •PRM transmit

•Accept V.54 or line loopback commands from remote

WAN 1 - 7 Interfaces

IP Defaults

•Off

IPX Defaults

•Off

AppleTalk Defaults

•Off

DECnet Defaults

•Off

T1 CSU/DSU Defaults

•Off

Image 16

Contents Octal T1-10/100 Riop Installation Guide Page Quickstart Instructions Table of ContentsIii Shipping Defaults LED PatternsNetwork Installation Quickstart ConfigurationShipping Defaults Introduction to the Octal T1-10/100 RiopConnecting the Octal T1-10/100 to the Ethernet Network InstallationConnecting the Octal T1-10/100 to a T1 Line Connecting a Management Console Powering Up the RouterEthernet Interface Configuration Quickstart InstructionsIP Protocol Required for IPAppleTalk Protocol IPX ProtocolDECnet Protocol WAN Interface Configuration T1 Physical Communications SettingsPPP Configuration WAN Link ConfigurationFrame Relay Configuration Required for IP Numbered Interface Frame Relay Dlci MappingsRequired for IP Unnumbered Interface Suggested for IPX Saving a Configuration File to Flash ROM Smds ConfigurationSmds Addressing Ethernet Interface Shipping DefaultsWAN 0 Interface IPX Defaults AppleTalk DefaultsT1 CSU/DSU Defaults WAN 1 7 InterfacesGeneral Indicators LED PatternsRouter LED Patterns Over TempEthernet Traffic Indicators T1 IndicatorsEthernet Connection Indicators T1 Connection Indicators