Chapter 5 - Setting Up Command Line Management | 15 |
Chapter 5 - Setting Up Command Line Management
The command line interface allows you to configure and monitor the router
ϖNote: Proper syntax is vital to effective operation of command line management. Case is not significant – you may enter commands in upper case, lower case, or a combination of the two.
Out-of-Band Command Line Management
You can use command line management and
In order to access the command line
1.Set a terminal or a PC equipped with VT100 terminal emulation to a baud rate of 9600, 8 bits, no parity, 1 stop bit and no Flow Con- trol.
2.Connect it to the router’s Console interface using the cable which was supplied with the MicroRouter 900i.
3.Press the <Return> key one or two times.
4.Enter the default password letmein at the password prompt. The command line interface prompt will appear on the screen.
If you plan to use
Temporarily Reconfiguring a Host for Command Line Management
You can temporarily reconfigure an IP host in order to set the server’s IP parameters to allow
If you wish to set the server’s basic IP parameters in this fashion, the host must be on the same Ethernet segment as one of the router’sEth-