Compatible Systems 900i manual Basic Configuration Guide, CompatiView Software Installation

Page 4

Connecting an Out-of-Band Management Console

11

Powering Up the Router

11

Chapter 4 - CompatiView Software Installation

13

 

 

CompatiView for Windows

13

System Requirements

13

Installing and Running CompatiView for Windows

13

Transport Protocols and CompatiView

14

Chapter 5 - Setting Up Command Line Management

15

 

 

Out-of-Band Command Line Management

15

Temporarily Reconfiguring a Host for Command Line Management

15

 

Setting Up Telnet Operation

16

Chapter 6 - Basic Configuration Guide

19

 

 

ETHERNET INTERFACE CONFIGURATION

19

IP Protocol

20

Required for IP

20

Suggested for IP

20

WAN INTERFACE CONFIGURATION

20

Physical Communications Settings

20

Link Configuration

21

Required for Dedicated/Leased Line Operation

21

Suggested for Dedicated/Leased Line Operation

21

Required for Dial-On-Demand Operation

21

Suggested for Dial-On-Demand Operation

22

IP Protocol

22

Required for IP

22

Suggested for IP

22

Link Configuration

23

Suggested for Dedicated/Leased Line Operation

23

Frame Relay DLCI Mappings

23

iv

Image 4
Contents MicroRouter 900i Installation Guide Page Introduction Network InstallationGetting Started Basic Configuration Guide CompatiView Software InstallationAppendix a Shipping Defaults Systems Appendix E Terms and ConditionsPage MicroRouter 900i Installation Overview IntroductionAbout the MicroRouter IntroductionNetwork Installation CompatiView Software InstallationCommand Line Preparation Basic Configuration GuideIntroduction Appendices Page Warranty and Service Getting StartedFew Notes Please Read The ManualsNeeded For Installation What You Will Need To Get StartedEthernet Connection Requirements Supplied with the MicroRouterTelco Line Connection Requirements Getting Started Thick EthernetThin Ethernet 10Base-T Twisted-Pair EthernetGetting Started Network Installation Mounting the RouterConnecting the Router to the Ethernet Connecting a Line Device to the MicroRouterConnecting an Out-of-Band Management Console Powering Up the RouterPage CompatiView for Windows Installing and Running CompatiView for WindowsSystem Requirements Transport Protocols and CompatiView Out-of-Band Command Line Management Temporarily Reconfiguring a Host for Command Line ManagementSetting Up Telnet Operation Setting Up Command Line ManagementSetting Up Command Line Management Page Basic Configuration Guide Ethernet Interface ConfigurationWAN Interface Configuration Physical Communications SettingsIP Protocol Required for IPLink Configuration Required for Dedicated/Leased Line OperationSuggested for Dedicated/Leased Line Operation Required for Dial-On-Demand OperationSuggested for Dial-On-Demand Operation Frame Relay Configuration Frame Relay Dlci MappingsRequired for IP Numbered Interface Required for IP Unnumbered InterfaceSaving a Configuration File to Flash ROM Page Appendix a Shipping Defaults Default PasswordEthernet Port WAN PortPage Pin Outs for DIN-8 to RS-232 Data Cable DCE/Male Pin Outs for DIN-8 to RS-232 Console Cable DTE/FemaleRx Data Tx Data Tx Clock Traffic Indicators Other IndicatorsLevel 1 Panic Indicators MicroRouter 900i Light PatternsMicroRouter 900i Switch Settings Appendix D Downloading Software From Compatible Systems Page Appendix E Terms Conditions Appendix E Terms and ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions Appendix E Terms and Conditions