Compatible Systems 900i Required for IP Numbered Interface, Required for IP Unnumbered Interface

TB: Use configure and set the DLCI keyword in the Frame Relay WAN 0 section.

IP Protocol

Required for IP

There are two ways to set up Frame Relay. One is to set the WAN inter- face as a “numbered interface.” This means that the interface (and thus the Frame Relay network) will have an IP address, subnet mask, etc.

The other is to set it as an unnumbered interface and specify that the link is point-to-point Frame Relay and set the local DLCI.

Required for IP Numbered Interface

•IP numbered interface

•IP address

•IP subnet mask

•IP broadcast address

CV: Use the TCP/IP Routing: WAN Dialog Box.

TB: Use the configure command and the Numbered, IPAddress, SubnetMask, and IPBroadcast keywords in the IP WAN 0

section.

Required for IP Unnumbered Interface

•IP unnumbered interface

•Point-to-Point Frame Relay

•Local DLCI

CV: Use the TCP/IP Routing: WAN 0 Dialog Box, and check the Point to Point Frame Relay checkbox.

TB: Use the configure command and the Numbered, PointToPoint- Frame, and InterfaceDLCI keywords in the IP WAN 0 section.

Suggested for IP

These parameters help supply information about the segment that the interface is connected to. With this information, routing can take place.

•Set IP RIP 1, IP RIP 2, or OSPF (Open Shortest Path First)

•IP static routes

CV: Use the TCP/IP Routing: WAN Dialog Box to set RIPor OSPF, and the IP Static Routing Dialog Box (under Global/IP Static Routes) to set static routes.