Compatible Systems 900i manual Link Configuration, Required for Dedicated/Leased Line Operation

Chapter 6 - Basic Configuration Guide 21

parameters will depend on the line communications device you are using.

ϖNote: Frame Relay and SMDS are presently supported in the MicroRouter 900i only via synchronous operation. An external clock signal is generated for Frame Relay.

CV: Use the Physical Configuration: WAN 0 Dialog Box.

TB: Use configure and set the LinkType keyword or other keywords in the RS232 Interface WAN 0 section.

PPP Configuration

This section covers the settings required for PPP (point-to-point) protocol operation of the WAN interfaces.

Link Configuration

Required for Dedicated/Leased Line Operation

Dedicated line operation is the simplest to set up.

•Set Dedicated connection

•Set PPP connection

CV: Use the Link Configuration: WAN 0 Dialog Box.

TB: Use configure and set the Mode and ConnectMode keywords in the Link Config WAN 0 section.

Suggested for Dedicated/Leased Line Operation

Dedicated line operation generally does not require additional parame- ters for operation.

Required for Dial-On-Demand Operation

Incoming dial-on-demand operation requires only slightly more infor- mation than dedicated line setup. Outgoing dial-on-demand requires additional information (see the suggested settings below).

•Set dial-up connection

•Set PPP connection

•Set to allow dial-in and/or dial-out

CV: Use the Link Configuration: WAN 0 Dialog Box.

TB: Use configure and set the Mode, ConnectMode, DialIn and/or DialOut keywords in the Link Config WAN 0 section.