3Com 9000 manual Configuring the Route Cache, Get Cache State

Configuring the Route Cache 399

Configuring the Route Cache

Get Cache State

The following commands allow you to set up the route cache parameters.

Get Cache State

Set Cache State

Get Cache Refresh for ADD PARTY

Set Cache State for ADD PARTY

￿Get Max Number of Routes per Cache Set Max Number of Routes per Cache

Display the current DTL cache state. The DTL cache state may be ENABLED or DISABLED. The default cache state is ENABLED.

Command Actions

Enter menu sequence:			(1) SYS: Platform Configuration
			(1) SET: Switch setup
			(9) PNI: PNNI Setup
			(4) CFP: Configure PNNI
			(6) SCR: Set Route Cache (UBR)
			Configuration
			(1) GCS: Get Cache State
Direct access sequence:			1 1 9 4 6 1
Command Result
System action taken:			The current DTL cache state is displayed.
System message display:			PNNI Cache (for UBR) is
			ENABLED/DISABLED.
			Press ENTER to continue....
Example
Enter: 1 1 9	4	6 1

The following message is displayed:

PNNI Cache (for UBR) is ENABLED.

Press ENTER to continue....