3Com 9000 manual 9 4 3 4 5 parameters

Setting the Timers 361

Set PTSE Refresh Sets the PTSE refresh interval value. The PTSE refresh interval is the Interval amount of time (in seconds) that passes before the next PTSE is flooded to all

the nodes in the current peer group. A change to the PTSE refresh interval value takes place after the next reboot.

Command Actions

Enter menu sequence:	(1) SYS: Platform Configuration
	(1) SET: Switch setup
	(9) PNI: PNNI Setup
	(4) CFP: Configure PNNI
	(3) NCF: Node Configuration
	(4) TIM: Timers
	(5) PRI: PTSE Refresh Interval
Enter a parameter at the prompt
Parameter	Format or Range
interval	1 - 60000 seconds
Direct access sequence:	1 1 9 4 3 4 5 [parameters]

Command Result

System action taken:

System message display:

The Hello inactivity factor is displayed and is updated to its new value.

Default value is <x>, new value is <y>

Example

Enter: 1 1 9 4 3 4 5 1500

The following message is displayed:

Default Value is 1800, new value is 1500

Press ENTER to continue...