360CHAPTER 11: CONFIGURING AND MANAGING PNNI

Set Hello Inactivity Sets the Hello inactivity factor. The Hello inactivity factor is the amount of Factor time (expressed in Hello intervals) after which the sending node will consider

a link to its neighbor down, if the neighbor does not respond. For more information on Hello intervals, see “Set Hello Interval” on page 359. A change to the Hello inactivity factor takes place after the next reboot.

Command Actions

Enter menu sequence:

(1) SYS: Platform Configuration

 

(1) SET: Switch setup

 

(9) PNI: PNNI Setup

 

(4) CFP: Configure PNNI

 

(3) NCF: Node Configuration

 

(4) TIM: Timers

 

(4) INF: Hello Inactivity Factor

Enter a parameter at the prompt

Parameter

Format or Range

interval

1 - 100 Hello intervals

Direct access sequence:

1 1 9 4 3 4 4 [parameters]

Command Result

System action taken:

System message display:

The Hello inactivity factor is displayed and is updated to its new value.

Default value is <x>, new value is <y>

Example

Enter: 1 1 9 4 3 4 4 10

The following message is displayed:

Default Value is 5, new value is 10

Press ENTER to continue...

Page 360
Image 360
3Com 9000 manual 9 4 3 4 4 parameters