Signaling Setup 169

Update VPI/VCI Update the VPI/VCI configuration parameters of the specified port. You Range set maximum and minimum VPI/VCI values for each port. For more

information, see “Display VPI/VCI Range” on page 167.

Note that when the ILMI auto-configuration procedure is enabled, the VPI/VCI limits are determined automatically and override any settings made by this command. (For more information, see “Display Current IP Configuration” on page 56.)

Command Actions

Enter the menu sequence:

(1) SYS: Platform configuration

 

(1) SET: Switch setup

 

 

(4) SIG: Signaling setup

 

 

(3) VCC: VPI/VCI range setup

 

 

(2) SET: Set VPI/VCI range

Enter a parameter at the prompt

Parameter

Format or Range

Port number

<slot.group.port> or 0.0 for all

Parameter number

1

for Min VPI

 

2

for Max VPI

 

3

for Min VCI

 

4

for Max VCI

Parameter value

The VPI/VCI value.

Direct access sequence:

1

1 4 3 2 [parameters]

 

Only one parameter can be defined per command.

Command Result

 

 

System action taken:

The selected VPI/VCI configuration parameters are

 

updated for the specified port.

System message display:

Parameter was successfully set.

Page 168 Page 170
Page 169
Image 169
3Com 9000 manual Information, see Display VPI/VCI Range on, Parameter Format or Range
Page 168 Page 170
Top Page Image Contents