344CHAPTER 11: CONFIGURING AND MANAGING PNNI

Set ATM Address Updates the last six bytes (ESI - End System Identifier) of the ATM address of the current node. A change to the ATM address takes place after the next reboot. For more information on ATM addressing in PNNI, see “ATM Address Format” on page 196 in the Operations Guide.

There are several PNNI operations in the LMA that can only be performed when the node administrative status is set to DOWN, and that take effect immediately after the status is reset to UP. These include updating the ATM address, updating the PNNI node id and updating the node level.

Command Actions

Enter menu sequence:

(1) SYS: Platform Configuration

 

(1) SET: Switch setup

 

(9) PNI: PNNI Setup

 

(4) CFP: Configure PNNI

 

(3) NCF: Node Configuration

 

(3) CHR: Characteristics

 

(2) ADD: ATM Address

 

(3) SAD: Set ATM Address

Enter a parameter at the prompt

Parameter

Format or Range

ESI address

Direct access sequence:

xx.xx.xx.xx.xx.xx

where xx are two hex digits representing a single byte.

1 1 9 4 3 3 2 3 [parameters]

Command Result

System action taken:

System message display:

The ESI of the ATM address of the current node is displayed and updated to its new value.

New ESI of PNNI Node ATM Address was

set, New ATM address is: <address>

Page 344
Image 344
3Com 9000 manual 9 4 3 3 2 3 parameters