358CHAPTER 11: CONFIGURING AND MANAGING PNNI

Set Hello Holddown Sets the Hello holddown timer value. The Hello holddown timer value is Timer the value (expressed in milliseconds) used by the specified node to limit the rate at which it sends Hello packets. A change to the Hello holddown

timer value takes place after the next reboot. For more information on Hello packets, see “Information Exchange in PNNI” on page 189 in the Operations Guide.

Command Actions

Enter menu sequence:

(1) SYS: Platform Configuration

 

(1) SET: Switch setup

 

(9) PNI: PNNI Setup

 

(4) CFP: Configure PNNI

 

(3) NCF: Node Configuration

 

(4) TIM: Timers

 

(2) HHD: Hello Holddown Timer

Enter a parameter at the prompt

Parameter

Format or Range

interval

1 - 30000 milliseconds

Direct access sequence:

1 1 9 4 3 4 2 [parameters]

Command Result

System action taken:

System message display:

The Hello holddown timer values is displayed and is updated to its new value.

Default value is <x>, new value is <y>

Example

Enter: 1 1 9 4 3 4 1 5

The following message is displayed:

Default Value is 10 (1 sec), new value is 5

Press ENTER to continue...

Page 358
Image 358
3Com 9000 manual 9 4 3 4 2 parameters